Brooklyn is in the house! Big Al, thanks for your dedication. Your comedy is sincerely appreciated. Praying for your speedy recovery. Up your beet juice with some ginger and bump them, Dr.'s. As the owner of a small, reliable toyota, it's time to upgrade to a used family car. What am I getting for the fam? I despise the dealer ship.
13 Chrisler 200, every so often check engine light comes on, when I park it at the house the next day check engine light is off. don't remember the code but it is vacuum leak, with the light coming and going at odd time make me think it is not mechanical. I did have to change the throttle body about 4 years ago for the same code. From Gulfport MS, I have thought about trying to clean throttle body.
Thanks for info guys I bench bleed fine and bleed brakes manually with someone pumping and me under neath 5 times brakes still went to ground and were soft was told needed scanner to allow abs module to open and allow fluid through. Shop said it still wouldn’t bleed after they tried 5 times so it’s confusing.Removal and install went smoothly took me 30mins which was my concern with time frame. Appreciate you guys! Love what you do
I saw your post on the live, 07 silverado if I remember, those are hard to bleed, you need a good scanner,I have a Snap on solis edge, on average it takes about 7 times, do the auto bleed with the scanner then bleed the wheels, the repeat, it also helps to drive it a few days then bleed it again, try to activate the abs on the road test, I have heard that you can bleed the brakes without a scanner if you do it with the engine running, I have never done that because I have a scanner, but have been told it works
Where is this lovely shop located Saving up for an Engine to resolve the leaking gaskets and seals for my 2008 Yukon Denali, and your favorite a failed lifter most likely due to low oil pressure issues
Hello 🤗 I was introduced to your channel when you spoke of the refrigerant 1234yf. May I ask what type of refrigerant is used for a 2017 F-Pace 3.0 AWD?
Got a 2005 Ford freestyle fail safe keeps popping up after I changed the throttle body I calibrated it and checked all wires for breaks and still failsafe comes on I have to recalibrate everytime it stalls out you got any advice? Thanks man love the content .
alex I pranked my #1 guy in my shop yesterday, he offered to change the oil in my 51 chevy pickup, he asked me if I had a filter, I pretended to be busy said just get one Mike, I had to leave the shop, I was going to bust out laughing, he was on his phone called Orielly, checking on the internet, it has no filter it was so funny Ithought I would try to get you, sorry for the prank, tell Shon please do not block me, it was all done in fun, love you guys!!!
Watching from Hattiesburg Mississippi. I watch you all video everyday throughout the day. I do not work on cars but really informative to watch. I learn something everyday. I drive a 2010 Nissan Altima base model so I be on you all videos hard 😂😂😂
Hello guys, my granddaughter has a 2012 Chevy Malibu TLZ. Has a misfire in cylinder 2. My son has changed the spark plug and coil, he has cleared the code (p0302) and it has come back. Any Suggestions?
It is great to hear you both discussing the Mopars and other motors. Should I get a Charger V6 for my better half. She has a Honda accord now We’re both listening
Hey how are you? Just finding you... I really need your help. I have a 2013 Dodge Ram 1500 5.7 Hemi Sport. Have you heard of the hemi tick? I have it, I just changed my oil to a higher grade, hopefully that works... What do you think it is?
Hello there, if you have the hemi tick. It most likely means you need to replace your lifters. I did a video about it here : th-cam.com/video/CPMC_f-goDU/w-d-xo.htmlsi=AlpbIvNJHH9tkais
@@AlexTheCarDoctorThank you! Where are you located? I would love for you to do the job, if thats the problem. I also have this winning sound coming from the back, i hear it, everytime I push the gas pedal... wht that sound like?
That's the way you do it. Husband and Wife can make the world go round.
Brooklyn is in the house! Big Al, thanks for your dedication. Your comedy is sincerely appreciated. Praying for your speedy recovery. Up your beet juice with some ginger and bump them, Dr.'s. As the owner of a small, reliable toyota, it's time to upgrade to a used family car. What am I getting for the fam? I despise the dealer ship.
Love the quality content and the attention to detail you both provide
Thanks so much brother! I’m in Morrow, Ga
@@AlexTheCarDoctor Thank you from PG, Maryland
On vacation in Panama and even while out of the country I’m tuning in.
Im like alex too hell if it can heal without stitches ,it will. 😂
😂😂😂 exactly!
13 Chrisler 200, every so often check engine light comes on, when I park it at the house the next day check engine light is off. don't remember the code but it is vacuum leak, with the light coming and going at odd time make me think it is not mechanical. I did have to change the throttle body about 4 years ago for the same code. From Gulfport MS, I have thought about trying to clean throttle body.
21:00 mark you said go find something that has issues, divorced because of that advise
How do I get on to ask a question?
the sunday live starts at 7pm, just leave a comment early they only have so much time
Thanks for info guys I bench bleed fine and bleed brakes manually with someone pumping and me under neath 5 times brakes still went to ground and were soft was told needed scanner to allow abs module to open and allow fluid through. Shop said it still wouldn’t bleed after they tried 5 times so it’s confusing.Removal and install went smoothly took me 30mins which was my concern with time frame. Appreciate you guys! Love what you do
I saw your post on the live, 07 silverado if I remember, those are hard to bleed, you need a good scanner,I have a Snap on solis edge, on average it takes about 7 times, do the auto bleed with the scanner then bleed the wheels, the repeat, it also helps to drive it a few days then bleed it again, try to activate the abs on the road test, I have heard that you can bleed the brakes without a scanner if you do it with the engine running, I have never done that because I have a scanner, but have been told it works
@@JimSix-jo6hfthanks man appreciate that a lot I’ll look into it more
Where is this lovely shop located
Saving up for an Engine to resolve the leaking gaskets and seals for my 2008 Yukon Denali, and your favorite a failed lifter most likely due to low oil pressure issues
Hello 🤗
I was introduced to your channel when you spoke of the refrigerant 1234yf.
May I ask what type of refrigerant is used for a 2017 F-Pace 3.0 AWD?
Got a 2005 Ford freestyle fail safe keeps popping up after I changed the throttle body I calibrated it and checked all wires for breaks and still failsafe comes on I have to recalibrate everytime it stalls out you got any advice? Thanks man love the content .
How about changing the VVT on that Scion Xb
alex I pranked my #1 guy in my shop yesterday, he offered to change the oil in my 51 chevy pickup, he asked me if I had a filter, I pretended to be busy said just get one Mike, I had to leave the shop, I was going to bust out laughing, he was on his phone called Orielly, checking on the internet, it has no filter it was so funny Ithought I would try to get you, sorry for the prank, tell Shon please do not block me, it was all done in fun, love you guys!!!
How about the 2013 Sonata?
Watching from Hattiesburg Mississippi. I watch you all video everyday throughout the day. I do not work on cars but really informative to watch. I learn something everyday. I drive a 2010 Nissan Altima base model so I be on you all videos hard 😂😂😂
Hello guys, my granddaughter has a 2012 Chevy Malibu TLZ. Has a misfire in cylinder 2. My son has changed the spark plug and coil, he has cleared the code (p0302) and it has come back. Any Suggestions?
It is great to hear you both discussing the Mopars and other motors. Should I get a Charger V6 for my better half. She has a Honda accord now We’re both listening
Keep that Honda 👀
Hey how are you? Just finding you... I really need your help. I have a 2013 Dodge Ram 1500 5.7 Hemi Sport. Have you heard of the hemi tick? I have it, I just changed my oil to a higher grade, hopefully that works... What do you think it is?
Hello there, if you have the hemi tick. It most likely means you need to replace your lifters. I did a video about it here :
th-cam.com/video/CPMC_f-goDU/w-d-xo.htmlsi=AlpbIvNJHH9tkais
@@AlexTheCarDoctoris that an expensive job.
@@AlexTheCarDoctorThank you! Where are you located? I would love for you to do the job, if thats the problem. I also have this winning sound coming from the back, i hear it, everytime I push the gas pedal... wht that sound like?