Definitely redeemed the sound compared to other videos... try to make your videos less lengthy... it's not like where listening to any of the talkin.. waste of 4min in 4:55 sec clip.. we watched 45s of it. 🤣🤣🤣
It felt smoother with tune during shifts, the power is also noticeable at higher rpms. If I shift from 1 to 2 near red line the front end kicks up about an inch. Also I did a burble tune so it def sounded better with the tune. I was getting 39 wheel hp after tune. Stock I believe is 35 at the wheel. Very slight but noticeable
It depends on the type of aftermarket if it has the cats or not. Best bet is to keep the oem pipe to swap out during inspection time. If not u can always throw a couple bucks at the guy to let u slide
These are the specs Lower fan temp settings (on/off 205/195) · Disable decel fuel cut for on/off throttle smoothing · Disable AIS valve · Disable stock O2 sensor · Custom ignition mapping to help reduce engine braking, make more power and smoother throttle transition · Fuel mapping changes for aftermarket exhaust
La moto anda menos ? Reacciona menos ? Porque dicen que se descomprime mucho con un full Sistem y que tiene menos reacción que con el escape de fabrica , esto es así ?
@@xsoobeastly3256 it depends. Some brands have diff headers, but if ur doing a slip on exhaust with stock headers the tone shouldn’t change much, just louder. Idk about the design of other brand headers but the akrapovic had like an H pipe style front header which created a deep almost muscle car note rumble
It still tops out about the same max around 113-120ish mph. But with mods you’ll really only see a gain around 0-60. Stock was hitting 5.3s and after mods like 4.9-5
I no longer have the bike but according to new owner the carbon pieces help up pretty well. I got it all from eBay I just searched carbon fairing for r3
If it’s custom you can request the burbles, a lot of piggy back or preset tunes might not have the same effect. Custom tunes are catered to what mods are already on the bike and if you want flames/pops the tuner can have that done for you. The brand/company doesn’t matter as long as they can build a custom map for you based on what you want
Personally I like the r3 for its style and also resell value is hot. U can sell it for what u get it for or even more due to hype. The duke 390 will deliver a bit more torque and upright seating if that’s what your going for
@@RickyMoto congrats Brotha, I have a question what you suggest. I’ve been in the market for an R3 for months now and their sold out still. They have a Mt-07. They’re trying to convince me to get it because I would get bored of the R3 less than Year.
Yea I’d say an r3 won’t take long to grow out of. A mt07 is a great bike, the power Is manageable like the r3 since it’s also a cylinder, but it has a bit more of a kick with torque
Problem with doing this or worse - full exhaust is you lose what people think is "back-pressure" misnomer, really they're referring to exhaust scavanging. By changing out your exhaust alone without the necessary ECU tune you lose torque at the low end. It's really noticeable for bikes with full exhaust change. The engineers put a lot of work in the stock exhaust setup which go hand in hand with performance. It's a crazy sounding thing put just a little change like this can have a huge impact on the performance. Most people don't even care or will even notice as their ass-dynos don't even know as long as it goes "vroom"....
I noticed that when I got the ecu tuned, it felt so much smoother and consistent in the power. Without tune low end just felt inconsistent almost like it wanted to stall
I will say the dual tip toce looks sick and better design wise, it was one of the options I was looking at when buying an exhaust but then wasn’t pleased with the tone compared to the Akra for my personal taste
Was thinking of just getting a slip-on, but I guess you convinced me to get the full system.
Slip on is nearly as same as the stock one.
What camera do you use??? It’s awesome
Eos r6
Definitely redeemed the sound compared to other videos... try to make your videos less lengthy... it's not like where listening to any of the talkin.. waste of 4min in 4:55 sec clip.. we watched 45s of it. 🤣🤣🤣
Sounds amazing, I got an R3 a month ago, and i'm definitely rocking a full system
That’s the move!
3:08 you're welcome
Hi Ricky. With the full exhaust, do you notice any difference in pwr or torq when riding after the ecu tune?
It felt smoother with tune during shifts, the power is also noticeable at higher rpms. If I shift from 1 to 2 near red line the front end kicks up about an inch. Also I did a burble tune so it def sounded better with the tune. I was getting 39 wheel hp after tune. Stock I believe is 35 at the wheel. Very slight but noticeable
Did you use power commander and dyno after changing the full exhaust?
I got a ecu tune
awesome sound man, i love the crackles, i might have to do one of these videos with my R3 because it sounds amazing ( probably better than yours hehe)
yah ok bro😂
What year r3 do you have?
@@kalonyt06 it’s a 2019
@@hawaiiktmadventures7720 bruh ?
There's no tune on that
2 vids at once sheesh
Where do u tune the r3 at a shop or by your self cuz I’m planning on getting a full exhaust and I want does pops too 🔥🔥 dope video too
Bauce racing in NJ, I mailed in ECU
Thxs
Who did you get your tune through. And was it just a flash tune or did you install a power commander
Bauce racing, it was a ECU tune i sent it in the mail and they tuned it then sent it back
@RickyMoto can I copy your tune plz I have the same bike as you
bauce racing, hit them up u can request any custom tune. I just asked for a burble tune and power increase
how did you repalce the side tuen signals on the bike. I been looking around and cant seem to find the replacement you have
It’s from Tst industries, flush mount
I love the carbon finish, may I know which part did of the motorcycle have the carbon finish? Getting inspiration from this
All the carbon is aftermarket
Do aftermarket exhausts still pass emissions? If not, how would you go about passing when the time comes?
It depends on the type of aftermarket if it has the cats or not. Best bet is to keep the oem pipe to swap out during inspection time. If not u can always throw a couple bucks at the guy to let u slide
Exactly, always keep oem parts and only delete the cats if you're confident you can reswap them for inspection.
And check with your state/county emission laws some don’t even require it
How much Is The exhaust
700
i can't believe it pops like that
It was the overrun tune
Thinking about going somewhere to get the cat cut of and a mid pipe welded from behind the sensor to the slip on and going somewhere for the tune
Love your setup. Who did you use to flash your ecu?
@@jamman1027 bauce racing in NJ
@@RickyMoto thank you 🙏
Damn this sounds really bad ass
appreciate it!
Sounds beautiful.
Elite channel!
Looking to get a R3 soon how tall are you btw?
I’m 5’ 7”
@@RickyMoto sweet bro taking my MSF course pretty soon! Loving your channel bro!
Sounds amazing 👏
That is why i love akrapovic
did you ecu tunrd?
Yezir custom flame/burble tune from bauce racing
Hey ricky , what specifications did you get for your ECU tune aside from a burble tune? Not sure what I should put in the form?
These are the specs
Lower fan temp settings (on/off 205/195)
· Disable decel fuel cut for on/off throttle smoothing
· Disable AIS valve
· Disable stock O2 sensor
· Custom ignition mapping to help reduce engine braking, make more power and smoother throttle transition
· Fuel mapping changes for aftermarket exhaust
La moto anda menos ? Reacciona menos ? Porque dicen que se descomprime mucho con un full Sistem y que tiene menos reacción que con el escape de fabrica , esto es así ?
The reduced back pressure from full exhaust will make low end torque a bit sluggish but after a tune it corrects it and rides smoother and faster
do all exhaust systems in general make the bike louder and sound better no matter the brand of it? or is it brand specific?
any exhaust sound better & louder than stock, the brand differences is mainly to do with the tone. Some pipes are higher in pitch, some are deeper etc
@@RickyMoto thanks! so sound and tone is just for the brand of muffler right? and the exhaust header itself will sound the same no matter the brand?
@@xsoobeastly3256 it depends. Some brands have diff headers, but if ur doing a slip on exhaust with stock headers the tone shouldn’t change much, just louder. Idk about the design of other brand headers but the akrapovic had like an H pipe style front header which created a deep almost muscle car note rumble
How fast could it go after you tuned it? I have an r3 and I want it to go faster, without buying something bigger and jumping by a lot.
It still tops out about the same max around 113-120ish mph. But with mods you’ll really only see a gain around 0-60. Stock was hitting 5.3s and after mods like 4.9-5
I absolutely love how your bike sounds like in this. What do I need to do to my akroprovic full system to sound like yours?
where you got your carbon parts from and how’s the bike so far
I no longer have the bike but according to new owner the carbon pieces help up pretty well. I got it all from eBay I just searched carbon fairing for r3
change the title to boring ramblings on a muffler i wanted to hear the sound of
Get a good quality headphones
does every R3 sound like that with a full akra exhaust ? holyyy
Tone wise yes. The pops and bangs was from tune
@@RickyMoto what tune specifically?
@rickymoto would a ecu tune from tst be the same?
If it’s custom you can request the burbles, a lot of piggy back or preset tunes might not have the same effect. Custom tunes are catered to what mods are already on the bike and if you want flames/pops the tuner can have that done for you. The brand/company doesn’t matter as long as they can build a custom map for you based on what you want
What a shaky hand
Too over exposed, you need an ND filter for filming outside
I had a variable nd on my lens but it was so bright I could barely see the screen so my adjustments were inaccurate. Will take note
Do you have to wear earplugs when riding because of the noise?
I have the slip on and it’s too quiet
Also did you get a tune or a block off plate?
I have a full system with tune and no block offs. I don’t wear earplugs
Wear earplugs . Earplugs are for wind noise not exhaust noise . Either that or prepare to be deaf in a few years . Learn from the old my dude .
@@Clipped115 Even with a full face helmet?
@@deedle6073 depends on how good quality the helmet is .
Snap, crackle, pop.
How much did the tune cost if you don’t might me asking
280
Does the exhaust also pops and bangs with the dB killer?
Haven’t tried, but if u tune it, it should work I’ve seen videos of ppl with pop/bangs with the baffles in
Doesn’t this exhaust not pass emissions
Potentially not tbh but never got it inspected after the install since I sold the bike afterwards
Can you take the sticker/ logo off the exhaust?
Yea but I’d recommend doing so prior to installing exhaust b/c the heat melts the adhesive stronger
Where do you get that plate support?
Tst industries
Burbles 🥵🥵🥵🥵
I am definitely gona shift to full system 🥵💯👍🏻
You have installation step by step vid?
I don’t sorry
What year is this r3?
2021
@@RickyMoto if you had a choice betweenthis R3 or duke 390 (*I'm in the market for a bike*)
Personally I like the r3 for its style and also resell value is hot. U can sell it for what u get it for or even more due to hype. The duke 390 will deliver a bit more torque and upright seating if that’s what your going for
You sold the bike 😢
Yuh, moving onto bigger and better soon. I do have a handful of r3 content I shot so I’ll be posting it soon
@@RickyMoto congrats Brotha, I have a question what you suggest. I’ve been in the market for an R3 for months now and their sold out still. They have a Mt-07. They’re trying to convince me to get it because I would get bored of the R3 less than Year.
Yea I’d say an r3 won’t take long to grow out of. A mt07 is a great bike, the power
Is manageable like the r3 since it’s also a cylinder, but it has a bit more of a kick with torque
Problem with doing this or worse - full exhaust is you lose what people think is "back-pressure" misnomer, really they're referring to exhaust scavanging. By changing out your exhaust alone without the necessary ECU tune you lose torque at the low end. It's really noticeable for bikes with full exhaust change. The engineers put a lot of work in the stock exhaust setup which go hand in hand with performance. It's a crazy sounding thing put just a little change like this can have a huge impact on the performance. Most people don't even care or will even notice as their ass-dynos don't even know as long as it goes "vroom"....
I noticed that when I got the ecu tuned, it felt so much smoother and consistent in the power. Without tune low end just felt inconsistent almost like it wanted to stall
@@RickyMoto Where do you tune it ? at a random garage or you actually have to go to Yamaha ?
Toc exaushts looks 1000x better…
Fr, how dare he do what he wants with his own bike?
Nah toce exhaust look like dog shit
I will say the dual tip toce looks sick and better design wise, it was one of the options I was looking at when buying an exhaust but then wasn’t pleased with the tone compared to the Akra for my personal taste
That cool sounds 😎 👌