Using MQ5 Gas Sensor with Arduino
ฝัง
- เผยแพร่เมื่อ 25 ก.ย. 2020
- In this tutorial, we will be learning how we can use MQ5 with Arduino to detect Gas Leakage in our environment.
Check out my blog : electronicseternit.wixsite.co...
Check out my FB Page : / electronicsforlife11 - วิทยาศาสตร์และเทคโนโลยี
I did two different MQ5 set with your video. In same environment, both give different values. What can i do about that, what is the problem?
You can try leaving the MQ5 ON for an extended period to season the sensors
@@electronicseternity9210 thanks for attention . i m going to try now.
Can I know the name of the wire used there
I guess you're referring jumper wire
@@electronicseternity9210 yeah thank you 💜
Good
Thank You :)
the arduino turns off when i plug the gnd to gnd and vcc to 5v pls help me
Check if you're Arduino is working. Then test your gas sensor. If your gas sensor, you might have to replace.
Try adjusting the calibrator as well
@@electronicseternity9210 i checked the arduino and its fine it probably my gas sensor
Can I see the codes
Refer my blog in the comment section
Buzzer not working
Please give the code
Hi, Code is in my blog
@@electronicseternity9210 i m getting error by this code please help me out
Do we have to use any library??
@@kixbix3292 No library is needed. What is the error.
Alarm was not declared in scope, exist status error,error uploading to arduino