The Easiest Way To Put Up Coving

I purchased this lightweight coving from Screwfix. Its called SuperCove. The best bit about it is you can put it up quick and easy. SuperCove sell pre made internal and external corners which makes life alot easier. I measure 83mm down from ceiling onto wall and get all my corners in first. All I have to do is measure and fit the straight lengths. The SuperCove adhesive which is in a tube applies so easy with a caulk gun and wipes off nice too. Job done.

[@robsoddjobs192]

Mate you are saving people thousands of hours I wasn’t seeing your videos then I checked and you had about 20 new ones!

[@stephenmahoney71]

Great video. I've got a box of the same stuff - one small point, according to the instructions its 83 mm not 38mm that you have to measure down. Thanks for explaining everything else for newbies like me though. 👍👍👍

[@danielnugentpainteranddeco557]

Thanks mate Nice one 👍🏻 👌

[@homemerce]

Great job on explaining the installation process! If anyone's ever in need of some high-quality coving, feel free to reach out to us!

[@danielnugent2168]

Cheers much appreciated

[@homemerce]

@@danielnugent2168

[@orbitalforest]

That looks nice and easy Dan , i do a little bit of coving once in a blue moon and always worry about it a bit as i don't do it regularly enough to be confident with it so i'll be getting this kit next time . Used to labour for my Uncle as a young lad doing Artexing & Coving , pretty much every house we coved he'd say " look at the bow in that ceiling....Robin Hood would have been proud of that ".😄

[@danielnugentpainteranddeco557]

Hahaha fantastic

[@RichardDowd]

He's done it again 😂🎉

[@danielwoolcock7267]

I've used this a few times Dan. It's so easy compared to the gyroc stuff and less messy. Also, I'm sure the adhesive doubles up as a caulk too?

[@danielnugentpainteranddeco557]

Mate its great stuff. A no brainer for us decorators

[@richardmcdougall233]

There is 3m lengths also. Less joins only minor issue is this coving is easily damaged when installing although l do use it.
l do my own mitres with the blue tool but external ones always takes longer getting them to meet perfect 😂

[@danielnugentpainteranddeco557]

@@richardmcdougall233 Mate I've damaged a couple of bits but a bit of Toupret Joint And Skim sorted it

[@GeoffRapley]

hi daniel. sorry to go off subject, but in one of your earlier videos you mentioned a neck support for painting ceilings. where did you get it from. ive looked on amazon but all i can find is soft ones. appreciate your help.

[@danielnugentpainteranddeco557]

Hi Mate. Ebay was where I found it as they seem hard to get hold of in UK. It came from Australia

[@NonaandBrody]

Is this 100 or 127, just checking for the 38mm you mentioned

[@danielnugent2168]

This was the 5 inch so 127

[@NannyJuju]

I wont buy the corners ready cut again, none of my corners will fit them, they are way out. (The corners that is.) Also at £11.99 for one box for two corners is a lot of money. Buy the strips with a plastic coving mitre plastic for corners, like the one you have.

[@danielnugent2168]

Yes it's expensive but I got the customer to pay. Saves time aswell.

[@beecee985]

Just finished large kitchen diner putting up supercove, so much easier to use, a lot quicker and less mess, forget gyproc, this is the way folks

[@danielnugentpainteranddeco557]

Hey mate. Totally agree 👍🏻