HVAC Disaster New Build...Revamped Our Own Ductwork
ฝัง
- เผยแพร่เมื่อ 21 ส.ค. 2024
- Here's a snippet of the horrible HVAC install our builder approved. We had to pause the build, bring in our own guy and redo the main trunklines just to have a decent system.
⬇️
✅ Watch the full HVAC redo video here: • HVAC Install Disaster ...
#construction
You should shout out the contractor that did the work correctly. Shout out his business. He does great work and deserves the referrals.
Good work ain't cheap, cheap work ain't good.
Good work is extremely rare regardless of how much you're paying.
Octoduct strikes again.
I think this guy saw the architect plans and mistook the tree out front of the house for his air handler
So many trunk lines. Never seen any thing like it. Interesting technique.
That's why the tin basher should always be a separate trade from the refrigeration mechanics.
Use ductless AC
What’s crazy is it’s not hard work it’s annoying work so you know the original installs were just lazy which is a poor excuse
What that is spaghetti!
Can't beat experience! Sexy sheet metal for sure!
Flex is okay if it's pulled within 4% compression rate, but only used as branches off a pressurized trunk.
Flex duct is so hard to clean.
Flex duct is trash
2nd guy cost twice as much or more.
And the second guy's system works properly, where the first guy's system is just a hack job that wasn't worth the money that was paid for it. What's your point?
@@CaptConfusion71the builder goes cheapest, not best. That's the point. You don't get a day in who the builder uses.
Low price get the awarded the project, exhibit A…
Wow 😮
So how’s you dad doing😂
Really, what inspector would approve the rough in. Why do I think this is fake? I’ve seen real amatures do a spider boxes better.
Nope 👎 so sorry this happened
Was u the original installer?
Did the guys who messed up have to compensate you?
The black duct tape says it all. Never
before and after both look horrible
What state is this in?
Utah
I tried to find someone to do metal. Everyone afraid of it.
They are not afraid they just do not have the skill set available in most areas. Sheet metal bending and learning how to make duct from sheet metal is a dying part of the trade. Because everyone just wants cheaper labor.
@@AJ-ox8xy mine far simpler than this video.
I may in the future pull the flex and run round metal myself. Pull flex lines off where needed.
I fear for our country. Skills are being lost.
You get what you pay for.
Fake. Nobody would waste their time doing this.
i would hire the fiirst hvac guy.. dogecoin
Hey, that's an insult to Dogecoin.
What do you expect when you buy one of those cookie cutter houses ?
Unfortunately this was a fully custom home, which made it much more annoying that our builder wasn’t on top of things