I just bought this item but the box doesnt have manual or instructions.. I installed this on my axial. The steering is good but there is no throttle and my esc is blinking. How to calibrate?
Unable to bind code: 1. First check if the pins on the receiver are reversed; 2. Are the distance between the remote control and the receiver too close, so there is no response 3. Are the batteries of the receiver and the remote control charged? 4. The power system can be replaced and tested, including the receiver.
Hola; no puedo emparejar mi transmisor con el receptor, en el vídeo no es muy claro. Podrían indicarme dónde puedo descargar un manual en línea, por favor. Gracias...
You can try the code first to see if it can be completed normally: 1. Connect the power supply to the receiver 2. Press the small button on the receiver (code matching button) 3. When you see the receiver light flashing, turn on the remote control 4. Code matching completed
I just bought this item but the box doesnt have manual or instructions.. I installed this on my axial. The steering is good but there is no throttle and my esc is blinking. How to calibrate?
What's your email address? I can send you a manual.
Not work
Why the green is Flashing and i try to connect nothing happens it keep flashing😢😢
Unable to bind code:
1. First check if the pins on the receiver are reversed;
2. Are the distance between the remote control and the receiver too close, so there is no response
3. Are the batteries of the receiver and the remote control charged?
4. The power system can be replaced and tested, including the receiver.
Hola; no puedo emparejar mi transmisor con el receptor, en el vídeo no es muy claro. Podrían indicarme dónde puedo descargar un manual en línea, por favor. Gracias...
My friend, you can provide your email address and I will send you the instructions.
Why led blu end green on not connected to transmiter
Hello can u help me pless😢 ..how can i bind the resiver CT -400A with the old trinmiter CT -400..???
Sorry, but the CT400 remote control cannot be coded and matched with the current F-04A receiver.
Why the green light on receiver only blink once??
How many volts is your battery?
my reciever is flashing blue and when i plug my servo to the 1st channel then it doesnt flash anymore. Could you help me?
You can try the code first to see if it can be completed normally:
1. Connect the power supply to the receiver
2. Press the small button on the receiver (code matching button)
3. When you see the receiver light flashing, turn on the remote control
4. Code matching completed
is it a good sign if its flashes blue? what do i need to do that it flashes green again
@@HotRC-Sophyi also bought a new reciever and its the same one and how do i connect the ner reciever to the ct 4a that i have?
@@D3adbreadz The operation method of connecting a new receiver is the same as the code matching step mentioned before.
@@D3adbreadz Only the blue light responds, but the green light doesn’t respond at all? Or what?