Although it can also be used as a conveyor drive. The best sealant was loctite 515. I was trained up on them. Our standard tolerences were 0.3 backlash, 0-0.01 mm on taper roller bearings, 0.3mm on cylindrical roller bearings, 0.35-0.4mm on spherical roller bearings.
This particular gearbox is used on the cranes to load and unload ships at the port. Gearboxes are use in many industries for different applications: marine, cement, paper, mining, wind, etc. As a reducer gearbox reduces speed and increases torque; as a increaser gearbox increases speed through different ratios of the gears/pinions (ex: wind turbing gearbox)
Seals...viton on the input packed with grease and lubed with loctite 567 on the outer diameter. I worked for siemens for 4.5 years, and I just started after the change over from flender. So I was taught by the flender people. I must admit that Flender quality is still far superior to other brands.
which type coupling this type gb use to couple prime mover?I think gear coupler is best due to higher reduction ratio with greater torque capable.and need 1500hp motor.
Dear all, I think we need discuss some information for alignment of this type gearbox. because I see the backlash depend the module of gear, the tolerance of tape roller bearing depend the length of shaft and size of bearing
![[LIVE] : ONE ลุมพินี 73 | คู่เอก "วรพล vs พันฤทธิ์"](http://i.ytimg.com/vi/rrOljlqse3A/mqdefault.jpg)
Although it can also be used as a conveyor drive. The best sealant was loctite 515. I was trained up on them. Our standard tolerences were 0.3 backlash, 0-0.01 mm on taper roller bearings, 0.3mm on cylindrical roller bearings, 0.35-0.4mm on spherical roller bearings.
This particular gearbox is used on the cranes to load and unload ships at the port. Gearboxes are use in many industries for different applications: marine, cement, paper, mining, wind, etc. As a reducer gearbox reduces speed and increases torque; as a increaser gearbox increases speed through different ratios of the gears/pinions (ex: wind turbing gearbox)
Seals...viton on the input packed with grease and lubed with loctite 567 on the outer diameter. I worked for siemens for 4.5 years, and I just started after the change over from flender. So I was taught by the flender people. I must admit that Flender quality is still far superior to other brands.
which type coupling this type gb use to couple prime mover?I think gear coupler is best due to higher reduction ratio with greater torque capable.and need 1500hp motor.
What's the Gearbox Used for? Like who uses them?
where is the pinion ? setting clearance 0.06, check contact 85% , check backlash 0.25. good.for tropic
Dear all, I think we need discuss some information for alignment of this type gearbox. because I see the backlash depend the module of gear, the tolerance of tape roller bearing depend the length of shaft and size of bearing