How to install a castle creations external BEC on a scx10 (RCCANADA)

small tutorial on How to wire a castle creations external BEC on your rig
it's mainly always the same pattern
special thanks to / 300728930035729
Don't know how to solder a deans connector? , want to learn how to solder properly?
• Video
Go check this video from our friend Squirellod
Make sure you come say hi on www.rccanada.ca forums the largest forums in all of canada!
make sure you subscribe if you like the video show your support!

[@MrDavide1976]

hi Sebastien! i'm using the castle creations 10amp ccbec with a hitec HS-7950TH and a spektrum receiver sr300. i searched for informations about my receiver trying to understand if it is good to deal with a servo that works at 7,4v. i didn't find anything. now i have my bec programmed to work to 6v. i'd like some counsel about this matter. after watching your video i thought it could be no problem to program the bec to supply 7,4v.
looking forward your answer.
Davide

[@charlestreibley9904]

Please note the Track Star TS3T with matching receiver you must use a Y connection and plug the BEC and the servo into channel 1 only, no other slot or combination will work. I tried them all. The symptoms where that the steering servo would work but no forward or reverse and the ECS beeping like it has not connection.

[@garymaddux2000]

this was helpful but i dont have a castle program card. i have other castle stuff like the sv3 and scte and 8th but i run them as is

[@clementleworthy5546]

Thank you this is very helpful