Hello. What inputs i have to use (or program) if i need to open gate from an extra source? Must be something like NO (normal open) terminals(dry). For example - i give a simple signal without any voltage, NO changes to NC (normal close) and gate opens.
Hello, i just installed the MCA2 and can't figure out the programming. I deleted the memory to start fresh and then enterered program level 1 and turned off automatic closing only and the exited programming mode to save but nothing happens when I press the buttons on the remote control afterwards. Motors do not move at all, only the. #4 led lights up when i press remote control button 1 and the #5 led lights up when i press the remote control button 2. That's all :( Can you please make programming videos? Thank you
Good morning HJ Gallego. We are willing to help you with your problem, please give me your email address and we will try to assist you the best we can.Failing that our telephone number in the UK is: 01623 558086.Best wishes,Nice UK LTD
So I was finally able to get the initial automatic install completed! Very happy. My only concerns now are how do I connect a wired open/close switch to the unit? Also, how do I speed up the gates open and closing process because it currently takes very long to complete the maneuvre? Thanks again.
Good afternoon HJ Gallego, You are correct the Step-by-Step command dose need wiring with one leg of your switch connected to terminal 15, the common for this connection is terminal 11. So connect your switch across 11 and 15, this should then operate the gates.I have also emailed you through some information regarding this control panel to the email address that you did provide.Best wishes,Nice UK LTD.
Hello. What inputs i have to use (or program) if i need to open gate from an extra source? Must be something like NO (normal open) terminals(dry). For example - i give a simple signal without any voltage, NO changes to NC (normal close) and gate opens.
Hello, is this unit compatible with the Nice IT4WIFI module? Thanks
Hello, i just installed the MCA2 and can't figure out the programming. I deleted the memory to start fresh and then enterered program level 1 and turned off automatic closing only and the exited programming mode to save but nothing happens when I press the buttons on the remote control afterwards. Motors do not move at all, only the. #4 led lights up when i press remote control button 1 and the #5 led lights up when i press the remote control button 2. That's all :( Can you please make programming videos? Thank you
Good morning HJ Gallego.
We are willing to help you with your problem, please give me your email address and we will try to assist you the best we can.Failing that our telephone number in the UK is: 01623 558086.Best wishes,Nice UK LTD
So I was finally able to get the initial automatic install completed! Very happy. My only concerns now are how do I connect a wired open/close switch to the unit? Also, how do I speed up the gates open and closing process because it currently takes very long to complete the maneuvre? Thanks again.
My wired remote open/close switch has two cables. I assume one cable goes to #15 input and what about the other cable?
Good afternoon HJ Gallego,
You are correct the Step-by-Step command dose need wiring with one leg of your switch connected to terminal 15, the common for this connection is terminal 11.
So connect your switch across 11 and 15, this should then operate the gates.I have also emailed you through some information regarding this control panel to the email address that you did provide.Best wishes,Nice UK LTD.
I also have same problem, can you help with that problem, my email: mantas.puskorius@gmail.com