ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
Wow brother your channel is full of all the essential designing a person should learn! Thanks for being such a big help
This is really nice. Good job. Keep posting and teaching.
Nice video, well done :)
That's amazing and so helpful. Thanks a lot
Why not use the trim tool in the weldments tab to trim the tubes instead of extruded cuts? It's much easier.
Hello, can you do a tutorial on a suspension fork?
DAMN MAN, U THA BEST...
Hello, in 09:32 why did you have to export the sketch and then open a new part and works from there?could you just carry on directly from there and make the pipes from the original sketch file?
same problem . PS: using Solid 2020
it is very useful for me thanks.
Thank you a lot... amazing^^ learning a lot from you...^^
I cannot understand what you did at time 42.52 sec. Can you please tell me. my SHOW SPLINE HEANDLES doesn't get highlighted . Please help
Did you end up with the standard 135 mm between the drop outs?
kept learning
it turns out you change the solidworks version from 20xx --> 2016 ,
Can you post the geometry of ur design
Hello sir, can you please send me the 2D figure of this. Please
Wow brother your channel is full of all the essential designing a person should learn! Thanks for being such a big help
This is really nice. Good job. Keep posting and teaching.
Nice video, well done :)
That's amazing and so helpful. Thanks a lot
Why not use the trim tool in the weldments tab to trim the tubes instead of extruded cuts? It's much easier.
Hello, can you do a tutorial on a suspension fork?
DAMN MAN, U THA BEST...
Hello, in 09:32 why did you have to export the sketch and then open a new part and works from there?
could you just carry on directly from there and make the pipes from the original sketch file?
same problem . PS: using Solid 2020
it is very useful for me thanks.
Thank you a lot... amazing^^ learning a lot from you...^^
I cannot understand what you did at time 42.52 sec. Can you please tell me. my SHOW SPLINE HEANDLES doesn't get highlighted . Please help
Did you end up with the standard 135 mm between the drop outs?
kept learning
it turns out you change the solidworks version from 20xx --> 2016 ,
Can you post the geometry of ur design
Hello sir, can you please send me the 2D figure of this. Please