Step 1: Roll the front windows down all of the way. This is for two reasons: A) It makes the first step of fitting the top of the door panel back on a lot easier (note the OP states this is the hardest step); B) you can tell right away if the new speaker is going to cause problems with the window.
Fantastic video! You did not rushed the pace, and showed what all the parts look like before proceeding to the next steps. Most importantly, video is very steady :)
Thank you very much for this video!!!!! Saved me a lot of money. I really appreciate you posting this. It is very detailed in the steps you have to take too.
Alberto Lopez If you're planning on splicing into the speaker wire, yes, you will need to disconnect. If you use an adapter, like I did, there is no need to cut into the wire.
Thanks for your useful videos for the Toyota Camry. Do you have a video for how to replace or remove the center armrest lid between passenger and driver seats for a 2012 Toyota Camry? Thanks.
i did a video on taking off the door panels on a 2015 camry, i explain how to put that lock handle assembly in place. if you look, there is a small slot, and the assembly has a plastic piece that has to line up and go in there, it snaps in. if you line of the screw hole first, then you will see the plastic piece that need to go through and snap into place.
Need to know what after market speakers will fit in the bracket???....also The rear.....in thought that's what your doing....but just reinstalled the factory crap!....lolz
What size are those speakers. And where can I get aftermarket ones. Because if you notice these don’t have the big magnet on the back of the speaker. So any speaker won’t fit you have to get on with a small magnet
Hi, I have a 2012 Camry and the front right side door got side swiped. If I get a door shell, can I reuse the parts I already have since it's only the exterior that is damaged? I think removing just the exterior skin (outer panel) and replacing it would be the easiest way to go but that would require specialized tools, hence I'm thinking just replacing the shell is the best way to go. Any advice? Do you have any videos on how to remove just the outer panel (skin)? This will be my first 'project'. Thanks in advance.
Hi very nice video. I have the same car and the door makes rattle sounds when going over bumps or potholes. Which part do you think make the rattle sound?
thanks mate. I've taken it to Toyota dealer but don't think they even looked at it after leaving it there for a day. But it rattles when i makes a turn or going over certain humps/potholes.
On my 2011, it was the shoulder belt adjustment. I tucked a piece of foam on each side, and the door area is now quiet. I also took off the door pull cover and put foam pieces then put the silver cover back on (about a yr ago).
Its part of the Schwaben 5 piece trim removal tool set. I got it online for around 20 bucks. I know that Harbor Freight also sells the kit for 7 dollars but I'm not sure if the quality is the same.
Thank you so much for your fast response, I also saw a camry se with xsp package, and heard dealers can sell and install those items. The dealership close to my home had no idea what I was talking about, have you heard about it?
please help, I'm struggling to take the driver side fender off on my 2015 avalin, there's a small piece next to the mirror which hides a bolt, I don't know how to take the piece out
jason yang 6 1/2 with an adapter and the back is a 6x9 in the back you will need to drill the holes to mount it or you can use the old mounting plate that is on the stock speaker and then use silicone to adhere it to the new 6x9 and then you will not need to drill any new holes
+Bryan M I'm sure it can but why would you want to? Removing the panel is not difficult nor time consuming. Better to do it right than to mess with splicing wires.
![🎤 จับฉลากร้องเพลง x P’ #XXSIVK [EP.1] (2/2) เพื่อนจับได้คำไหน..ต้องร้องคำนั้น เริ่ม! 💓🎶 #MXFRUIT](http://i.ytimg.com/vi/1bJvMJXmeS4/mqdefault.jpg)
![Megan Thee Stallion - Neva Play (feat. RM) [Official Video]](http://i.ytimg.com/vi/TpYTyAaTRts/mqdefault.jpg)
Step 1: Roll the front windows down all of the way. This is for two reasons: A) It makes the first step of fitting the top of the door panel back on a lot easier (note the OP states this is the hardest step); B) you can tell right away if the new speaker is going to cause problems with the window.
Great video, followed it step by step and was able to replace the mirror on my sons car. Saved a lot on money by doing it myself.
Fantastic video! You did not rushed the pace, and showed what all the parts look like before proceeding to the next steps. Most importantly, video is very steady :)
Thank you very much for this video!!!!! Saved me a lot of money. I really appreciate you posting this. It is very detailed in the steps you have to take too.
Great video! Used this to get me to the door lock actuators.
Great video, thanks for posting!!! Would love to see a video on how to install rear speakers on the 2012-2014 camry next.
thoughs are more of a pain to do. a lot of dismattling
Raul Romo
did you disconnect the negative cable on the battery first
you dont have to disconnect the negative on the battery.
Alberto Lopez
If you're planning on splicing into the speaker wire, yes, you will need to disconnect. If you use an adapter, like I did, there is no need to cut into the wire.
qwerty135797 Thanks for the info.
Thank you Ron Swanson!
This is an awesome video! definitely going to be able to upgrade my speakers with ease with the help from this video!
Nice step by step instruction, great job!
Easiest to understand door panel removal video on TH-cam!
Tanks Bro I going to remove my doors panels to paint them and this video it helps me tanks again
Thank you - just what I needed to debug a door rattle. Now I can locate it.
Good info on removal of the door panel...
It's easier than I thought.
Thank you for the great video. Made life easy
Thank you for sharing this information
why have you removed a mirror?
Why remover the side view mirror though? Is that mandatory for electrical reasons?
No. Not necessarily at all
Fixed my rattling speaker. Thanks!
Thanks bro! Very useful information!
Nice video hey do you know the correct Speaker size thanks
what brand are the original speakers on this vehicle?
This was super helpful! Thank you
Thanks for your useful videos for the Toyota Camry. Do you have a video for how to replace or remove the center armrest lid between passenger and driver seats for a 2012 Toyota Camry? Thanks.
Great work
Well done and very helpful to me.
does the speaker grille separate from the trim, I damaged my speaker grill and looking to replace that piece
Hi, can you post a video on How to install a Side Turn Signal indicator? Or remove the side mirror covers. Thanks so much!
Thanks, this worked perfectly.
Do I need a bracket to replace the speakers with 6x9
What size speakers are they?
Thanks for the video. I had a hard time to put back the opener and lock handle assembly in place. Do you have any tip or guide on this?
i did a video on taking off the door panels on a 2015 camry, i explain how to put that lock handle assembly in place. if you look, there is a small slot, and the assembly has a plastic piece that has to line up and go in there, it snaps in. if you line of the screw hole first, then you will see the plastic piece that need to go through and snap into place.
I had same problem. You have to slide the plastic parts so they are separated when you plug it in at first, then push down on the part that clips in,
Need to know what after market speakers will fit in the bracket???....also The rear.....in thought that's what your doing....but just reinstalled the factory crap!....lolz
The stock speakers are 6x9s. You can fit 6x9s and you can also fit 6.5s with a kit
I have an 8” Beyma in my door. You can fit 8” as well
Merci,Comment démonter le poignet côté conducteur Toyota Cambry 2003
What size are those speakers. And where can I get aftermarket ones. Because if you notice these don’t have the big magnet on the back of the speaker. So any speaker won’t fit you have to get on with a small magnet
Hi, I have a 2012 Camry and the front right side door got side swiped. If I get a door shell, can I reuse the parts I already have since it's only the exterior that is damaged? I think removing just the exterior skin (outer panel) and replacing it would be the easiest way to go but that would require specialized tools, hence I'm thinking just replacing the shell is the best way to go. Any advice? Do you have any videos on how to remove just the outer panel (skin)? This will be my first 'project'. Thanks in advance.
Its easier putting back the door panel if you remove the window seal clips.
Very helpful, thanks.
Hi very nice video. I have the same car and the door makes rattle sounds when going over bumps or potholes. Which part do you think make the rattle sound?
you would have to take it apart to see. nothing really should be rattling. sometimes the little light comes apart, but that's about it.
thanks mate. I've taken it to Toyota dealer but don't think they even looked at it after leaving it there for a day. But it rattles when i makes a turn or going over certain humps/potholes.
Have not had a look at it myself but I've taken it to Toyota and I don't think they did much if anything at all. I'll mention it on my next service.
On my 2011, it was the shoulder belt adjustment. I tucked a piece of foam on each side, and the door area is now quiet. I also took off the door pull cover and put foam pieces then put the silver cover back on (about a yr ago).
Thank you so easy now
What size is the original speakers
If you are taking the door panel off do not remove the side mirror.
What was the point of removing the side mirror??
Does anyone know what brand door speakers a 2013 Toyota Camry LE comes stock with?
thx for for video so helpful. can please put video for inner roof panel. removel
Thanks for the video, what is that blue tool you are using at the start of the video? I prefer not to use flat screw driver.
Its part of the Schwaben 5 piece trim removal tool set. I got it online for around 20 bucks. I know that Harbor Freight also sells the kit for 7 dollars but I'm not sure if the quality is the same.
Thank you so much for your fast response, I also saw a camry se with xsp package, and heard dealers can sell and install those items. The dealership close to my home had no idea what I was talking about, have you heard about it?
Inzee zaman Haven't heard about it but it looks like its only offered by Southeast Toyota dealers.
please help, I'm struggling to take the driver side fender off on my 2015 avalin, there's a small piece next to the mirror which hides a bolt, I don't know how to take the piece out
most have a small cover that you just have to get under to pop off and there is a screw under that.
It's just how to remove the rear door it doesn't say door panel I'm looking for a video to how to remove the rear door
is it the same for the 2015 Camry
so a 6x9 would fit together with a metra adapter?
thank you sir sooooooo much
Hi could you please add a video how remove passenger side (R) fender, or any suggestion. I need to work on my fender. Thanks
Useful tnx.
Struts back side 2014se. Please
Why remove the side mirror?
Is it the same for the Camry 2017?
Yes
Out side door handle how to removal?
thank you
*Where can I buy the Black door trim?*
what size were the front door speaker? look like 5in speaker but in a 6x9 frame.
jason yang 6 1/2 with an adapter
and the back is a 6x9
in the back you will need to drill the holes to mount it or you can use the old mounting plate that is on the stock speaker and then use silicone to adhere it to the new 6x9 and then you will not need to drill any new holes
can wire be spliced to new mirror so panel not need removal?????
+Bryan M I'm sure it can but why would you want to? Removing the panel is not difficult nor time consuming. Better to do it right than to mess with splicing wires.
+happywrenching yeah that's what all mechanics say so they can take their little fucking time an make people pay them more
so If I saw this correctly, you have to remove the whole panel to unclip the wire for the side mirror? yikes
Yeah, whole panel has to come off. Lot of work just to unplug a silly wire.
Going to replace the passenger mirror. Very good video. Thanks.
what was the point of taking the mirror off?
for spray paint the whole surface
For replacing the mirror when your wife hits a road cone on the highway.
I don’t see any point of removing the side mirror...
Thats what I said...
He was trolling 😂😂
How to replace front door handles.?