Replace the bendix drive Kymco / Gy6 scooter

Appendix: bit.ly/331QKRF
Is your bendix defective or worn out and do you want to replace it yourself? In this montage video we show how you can easily replace the bendix yourself.
Tools that we use in this video:
- Kymco blocking key: bit.ly/2KeXAL3
- China / Gy6 scooter blocking key: bit.ly/2SjkxjO
- Copper grease: bit.ly/2ECrhEm
- Ratchet set: bit.ly/2ElcxrY
#bendix #supplied #Kymco

[@imedhelal9084]

Merci beaucoup

[@DRAGNET-pn5vf]

THANKS FOR SHARING.🇺🇲✌️👍

[@zandrishop]

you're welcome

[@dolfgoog]

Kopervet is niet in eerste plaats bedoeld om te smeren maar om vastzitten te voorkomen (anti-seize). Wordt doorgaans gebruikt op bv bouten. Voor de bendix kun je m.i. beter gewoon lagervet gebruiken.

[@zandrishop]

Klopt helemaal.

[@ivokraaier9740]

wordt ook gebruik in big-end lagers van hoogtoerige rc tweetaktmotortjes, dus kwaad kan het niet.

[@Sergiodemiranda1986]

Hoe zit dit vast bij valt ie er steeds uit al vanaf ik de scooter heb

[@vlaicux]

De unde pot lua și eu sa pot bloca variator cu tabla ce ai prins-o pentru blocare?

[@johnobotgaming5801]

Hi. Where can I get a gear block out key? I also need to replace the bendix but I don't know how to stop the gear wheel from spinning.

[@zandrishop]

www.zandri.nl/blokkeersleutel-gy6-4-takt-endurance.html

[@felipejansen7200]

Zit er een andere in of is dit de zelfde bendix

[@Chris-di9xh]

Sinds ik mijn rollen heb vervangen hoor ik bij het elektrisch starten een heel scherp geluid van m'n starter krans komen. Ik heb alles goed gemonteerd naar mijn idee. Wat zou dit kunnen zijn?

[@zandrishop]

Ligt eraan of alles goed op de plek zit, haal het los en bekijk even of er slijtage te zien is

[@mkpat3237]

Does the pointy end of the Bendix need a spacer between itself and the case?

[@rubenotero7100]

try 8mm inner diameter, 12mm outer diameter, 9mm long bushing.

[@ucheike8438]

Wat is dat kleine tandwieltje wat schuin achter de bendix zit?

[@zandrishop]

dat is de startmotor

[@user-gt3iy2iv5q]

How much torque on the variable nut? And what size is it?

[@zandrishop]

in dutch whe says ''dop 17'' Torque: 5.5~6.5kgf-m

[@son8964]

Mijn bendix zit los en hangt naar beneden waardoor die de starterkrans heletijd aantikt als die aan is?

[@zandrishop]

Advies is na te gaan of de bendix versleten is

[@Kdjoao]

My rear wheel not spinning. Think its the bendix, or the thing that make the bendix spin out

[@ivokraaier9740]

neither: bendix is for starting the engine with electric starter motor, not to drive wheel.
you should be looking at the variator, drive belt and clutch (near rear wheel) if motor does run.

[@stew-pid8226]

Will this process with the same on a Sinnis Matrix 3i?

[@zandrishop]

we dont have tecnical information about the sinnis matrix 3i

[@felipejansen7200]

Hallo ik vroeg me af wat je nou precies in het gat doet waar de bandix uit komt

[@zandrishop]

wordt vet in gesmeerd

[@mobouhou3807]

Kopervet

[@020matrix]

@@mobouhou3807 beter is kogellagervet

[@e.w.7283]

Ich würde den Variodeckel nur abbauen und nicht zerlegen, weil er wieder angebaut werden muss. Aber hier lernt man wie man schrauben raus und wieder rein dreht.

[@user-po2fx1cc4h]

I see you use copper grease everywhere? Why didn’t you clean and remove the dirt in the variator? Wasn’t it possible to remove the Bendix without unscrewing the front variator? With the 139 QMB engine, the bendix comes out easily, and there is no need to unscrew the front variator.

[@zandrishop]

I will forward your advice to our mechanic. Thanks.

[@user-ms9ix7is3d]

Bjr jai besoin vous stp vous savez pas pk moi scooter kisbee Peugeot 4t veux pas démarrer cest normal que la pièce que vous remonter sur la vidéo elle bouge pas et moi si

[@catalinmanolea6844]

I put a new bendix on it and it rotates a little, the pulley locks

[@zandrishop]

can be multiple factors. How is the battery voltage and is the starter motor still OK?

[@catalinmanolea6844]

@@zandrishop the battery is bought new i changed the engine set new bendix new

[@catalinmanolea6844]

You give me the instagram address to send you a video

[@kadenreynolds3137]

@@catalinmanolea6844 does it have a slow crank? my gy6 moped is having a slow crank issue. did you figure out what causes it

[@voutes334off8]

I gave problem with my kick on this pls helpscooter

[@zandrishop]

What exactly is there then?

[@thelagmeister]

The kick starter breaks very easily on these scooters. The cvt cover might be broken. there is a tiny piece of the cover that breaks off if you use the kick starter too much.

[@gregmeeks2753]

no sound ?

[@zandrishop]

That's right, we make videos on how to assemble parts. Then sound is not necessary. Tip, you can enable translation to keep track of what you need to do.

[@thomashoyle1501]

Ik zie het daar niet zitten op de sym fiddle II 2009...

[@zandrishop]

Dit betreft ook een Kymco scotter, geen Sym Fiddle.

[@philippesilva2275]

Get a impact sir

[@020matrix]

hahaha yeah rigth we al got an impact at home rigth?
No need for an impact at all!