Great question. Yes absolutely you need to take off the holster part then unscrew the mounting plate (there should be three screws holding it on) then you just slide the leg strap up in place and redo the screws and you should be sorted. The other option is to try and thread it through the mounting plate but that might cause an issue when you come to putting the holster back on
To be honest mate I have no problems drawing it from just the S Loop but my buddy had put a leg strap on it and I’m planning on doing it just to see what it’s like. The only reason I get a couple of drawing issues is because it’s too far back on my belt because I need to redo my belt set up
All brands of glock will fit in this holster. You may have to make minor adjustments by sanding out some of the insides of the holster because some glocks are bigger than other. It’s obviously made for the genuine glock real steel however for some reason airsoft glocks seem to be slightly wider
what brand is your molle belt?
It’s the FRV tailoring mtp shooters belt
Hahahaha as if you’ve spent £100 on a belt and don’t even know how to wear it properly 🤣🤣🤣
What brand is your trousers
They are the MTP aircrew trousers used by army air corps and raf aircrew
Can I attach a leg strap to it to keep it in place in a draw?
Great question. Yes absolutely you need to take off the holster part then unscrew the mounting plate (there should be three screws holding it on) then you just slide the leg strap up in place and redo the screws and you should be sorted. The other option is to try and thread it through the mounting plate but that might cause an issue when you come to putting the holster back on
@@allykitreview121 thanks alot for the reply it will make drawing easier due to it being mounted to my belt and thigh
To be honest mate I have no problems drawing it from just the S Loop but my buddy had put a leg strap on it and I’m planning on doing it just to see what it’s like. The only reason I get a couple of drawing issues is because it’s too far back on my belt because I need to redo my belt set up
@@allykitreview121 yeh i run my pistol quite far foward and i just like when things dont move so i know exactly where it is at all times
Yeah that’s totally understandable buddy I’m the same
What brand glock fits in this holster
All brands of glock will fit in this holster. You may have to make minor adjustments by sanding out some of the insides of the holster because some glocks are bigger than other. It’s obviously made for the genuine glock real steel however for some reason airsoft glocks seem to be slightly wider
Yeah man as I say some fit some don’t it just depends on the model. Most will need so sorting for it to fit
@@allykitreview121 where did you have to sand? Just down the sides, or round the ejection port safety, too?
It was actually the inside of the holder I sanded down mate not the top slide
@@allykitreview121 yeah thats what I meant. Just the sides inside the holster, or the top where the sprung ejection port catch is, too