How To Make Your XMAXX Bullet-proof Step 1 RPM Hinge PIns And Bearing Carriers

In this video i show how to make you XMAXX much much more reliable out of the box. My videos are slow paced and intended for the new XMAXX owner. I work slowly so that you can follow along and work along side me. I hope this video is just what you needed!
XMAXX playlist: • X-MAXX How to videos
Tools and Materials used in this video
Hypertough screwdriver
www.walmart.co...
Dewalt screwdriver
www.homedepot....
Traxxas tool set
traxxas.com/pr...
Ball-end allen bits
www.amazon.com...
Harbor freight magnetic parts dish
www.harborfrei...
Harbor freight-Loctite
www.harborfrei...
Gorilla Super glue
www.walmart.co...

[@Citizendefenseindustry]

Great video. My xmaxx is being delivered tomorrow. First rc car. I did not know you had to countersink the screws. thank God I watched this because I just bought a step bit and hinge pins and knuckles just in case anything breaks, I'll be ready.

[@user-jg6lg3vq3m]

Your utube helped me make my xmaxx, thank you so much

[@texasta-mater7367]

I replaced all my hinge pins with small stainless steel bolts from my local hardware store. I noticed you tightened yours pretty tight. I found that it makes the suspension too tight so I used lock nuts and had to back off the nuts just a little to get full range of the suspension without any extra resistance.

[@___Aaron___]

So why not pin the body side of the A-arm too? I get doing the hinge pins on the wheel side.. but what about pinning the body side of the arm. Wouldn't that make it more bullet proof..

[@wickedmaine207]

never put hand behind where the drillbits going lol my dad would have called me a name lmao

[@DashzRight]

I have been using these long cheap hex screws as hinge pins from aliexpress for 4 months now, I guess Im either too good jumping the car or I dont jump high enough lmao.
Good vid

[@jimjimmyjam8242]

nice video I love my xmaxx

[@justindrumm8]

Great video. Came to see about doing the rpm hinge pins, but i noticed you didnt oil the rpm bearings before popping them into the knuckles.

[@justincase948]

The hot racing are better and cheaper 👍👍👊🏻👊🏻

[@Jimjumjimmy]

Thanks this good 👍

[@wickedmaine207]

this is not how to use a drill but still a good video

[@kenbaldwin888]

The hell with all that plastic sheet do aluminum you never have to replace anythin

[@jimmygeorge4268]

GREAT VIDEOS SIR,,,,BTW…..I have a hyper tough drill too,,,,but mine has a clutch on it,,,,,,it’s red in color……I bought it at Walmart,,,,,the adjustable clutch works great,,,has 5 settings on it…I bought it 2 years ago….check it out….

[@rickyemrick3853]

Will these work on the XRT too?

[@skybasherrc2372]

Liked and subbb'd 👍

[@koolkiwikat]

bro love the content, video res is trash....its not the 90's