ฝัง
- เผยแพร่เมื่อ 2 ต.ค. 2024
- any tips for skullcam... leave them in the COMMENTS.. also feel free to join the skullcam pocket bike community by SUBSCRIBING.. and give the VID a THUMBS UP for a LIKE.. if you would like to see more of this super pocket bike build.!!!
![[Full Episode] The Restaurant War Thailand ศึกพ่อค้าซ่าแม่ค้าแซ่บ Episode 2 | 29 ก.ย. 67](http://i.ytimg.com/vi/r3lfLNH6Ke4/mqdefault.jpg)
I also carry a pin in my tool box , secret weapon for carbs!
haha yes very handy
I would check the wiring out, make sure the ground wire is still on the block of the engine. Or check the kill switch to make sure it’s not wired wrong. Just some other things to check 👍🏼 seems like it has everything else good compression, spark, etc. keep up the great videos!
yeah not sure whats going one with it... ill keep working at it .and yo stay tuned for more vids..
Starter fluid dude
dude take the spark plug out check it clean it off then spray some starting fluid in the spark plug hole or even just a couple drops of gas and see if it even tries to kick on if it doesn't u know ur not getting a spark or maybe u have a problem with something not being sealed properly.
thanks for the tips
Advust idle screw all way down then two turns up
if there are not spark could be the stator
had spark in the last vid when i checked, but i should check for spark again just to be sure
Hey mate I have a 49cc quad have swapped motor etc and gave it a good little make over and changed the jets but its still a prick to start what would you reckon is wrong with it
man i have had pocket bikes that are hard to start..... other than having a nice clean carb ..and clean fuel .. check for any air leaks ,,there hard to find some times but can also cause a hard to start problem ...make sure it has a good brand spark plug... and have a look at the coil and fly wheel where those two little magnets are... make sure the gap is set right.... and they are not rusty... if all that is good... the way i start a hard to start pocket bike is.... choke on.. rev it up a few times... prime it slowly a few times with the pull start... then try start it once or twice with the choke on..give the throttle a little twist as you pull... then try start with choke off ..man if all that dont work.. just keep trying..one old pocket bike i got from a mate took two days .. trying to start after i striped the engine down cleaned it and put it back together... hope this helps bro
@@skullcam OK awsome mate I did the same pulled engine out and stripped it all down check all gaskets they all look OK and changed the jets as they were a little old
Dont throttle it u flood it
does it have a clutch if so try bump start it, im thinking the timing is off because the side cover that u check the timing from is off the motor the little hole on the magneto side
yeah nar its a auto bro..so yeah that sucks .. hey and yo im checking the timing now for the next vid
sweet man should try and upload 2 times a week cause i enjoy watching haha
yeah i agree man ...im working on being more regular with uploads 2 a week would be a good goal for skullcam to get to
try putting some fuel in the spark plug hole...
haha,... yo why didnt i think that,,, dang... ill do that in that next vid
o yea bro my bike still in the shop
dang both our bikes are broke
I could get that bike started easily
bro if ya lived close ..i would get you to come over and help..that would be mad
wa can I make a vlog it about
yo vlog wat ya like man dont hold back..if any of my vids inspire you to vlog about some thing that means im doing my job... thanks for your support to skullcam bro
I think you need to re adjust your kick starter look like it needs to be turned up so it’s up higher .i don’t think you getting a big enough kick ratio to turn the bike over .
yo thanks for the tip bro..ill check that one out... your the first one to mention this tip...
@@skullcam i had the same issue in my pitbike build video couldnt get a full revolution .it will just give you a brighter spark amd will gove it a proper turn over.if its been sitting that long it can use all thw help,it can get 😃
Check to see if there is any spark?!!!
yo thanks for the tip and thanks for watching...
No worries, did notice that the wires from kill switch aren't connected hence why i ask if there is any spark!!
yeah thats just the old kill switch wires ..the one with the key is the one connected
he checked last video if u watched it
yup it had spark in the last vid ..
My boy skullcam!!! hope you had a great day buddy
yo..sure will ....thanks for tuning in and the comment man
Try turning the engine over by electric start. And check for spark
yo had spark last time .. but i will check it again... and i cant electric start until i get a battery ..hey thanks for the tips..