How to install an LED Flasher Relay on a 2016+ Yamaha XSR700 by TST Industries
ฝัง
- เผยแพร่เมื่อ 5 ต.ค. 2024
- Our plug-and-play LED Flasher Relay will fix your fast flash rate problem caused by aftermarket signal lights and/or an integrated taillight. For more info see: bit.ly/2JLl1xP
Make sure to subscribe here: bit.ly/1jq2ZrN
Follow us on Facebook here: on. 1nuTjlF
Follow us on Instagram here: / tstindustries
Follow us on Twitter here: / tstindustries
If your signal lights flash too fast then this part is your hyperflash solution. It is very easy to install and does not require any special tools as it plugs right into the OEM harness. This component works with the following signal configurations:
1. All stock
2. Stock taillight, aftermarket signals
3. Integrated taillight, stock signals
4. Integrated taillight, aftermarket signals.
We designed this part to fit exactly like the OEM part so the installation is very simple.
hi. do you have a video on how to remove the rear signal lights? thanks
Did you have to upgrade the flasher relay as well?. I’ve seen a lot of videos with a after market indicators blink too quick and the really slow them down. I have a 2021 xsr700.
Yeah on this bike, when you replace OE signals with LED type, the system will hyperflash. The remedy is replacement of the relay with the one we sell and show the installation of in this video,
this install will 'fix' all 4 led indicators, correct? And also work for hazard lights :)
Yes. All signal lamps are controlled by one relay.
Do you know if this is the same relay part as a Yamaha Bolt or is it different?
how many pins does that flasher have? 2 or 3..., because there are some that are grounded... thanks
Ours uses 2. It does not need a ground. It replaces grounded units as well as units with no separate ground.
hi, can you tell me which relay I have to mount for xsr700 (led arrows) your link takes me to the honda cbr. Thank yo
That is the correct link. Only one photo shows it installed on a CBR but if you scroll down and look at the applications table, the XSR700 is listed. Please be sure to read the product page in full before making a final purchase.
does it come pre programmed already at 85 cpm? i dont wanna have to adjust myself, ill probably have it all out of whack lol
The relays come preset to 85 cycles per minute
TSTindustries awesome thanks so much. I installed the fender eliminator on my 2008 wr250x today and I’ll be putting the relay in tomorrow 👌🏼
What's the trick for getting the rubber boot over the tab? Lol
Sometimes a flathead screwdriver between the tab and relay housing helps get the rubber keeper on.
@@TSTindustries thanks. I had my wife get it over the clip. 🤣