You can use cutting fluid to improve the finish. I didn't lap the valves in after cutting with Neway. The results were good and the engine has been running well for several years and around 60k km. The rings left by the cutter get flattened when the valve closes during use, which gives a good seal. I prefer the tapered guide. Please treat your tools more carefully, any damage can decrease their effectiveness.
I picked up a second hand set with a couple of cutters for around £120. Only had a 45 degree that would fit inlet and exhaust. Have priced up a 30 and 60 degree from Neway (sometimes on eBay). Did a test cut ok but could do with the two handed rotating adaptor to ensure better concentricity.
You can get new ones from Cylinder Head Supply. They are a bit expensive and they work really well in my somewhat limited experience. I’ve done three cylinder heads with my set.
Did a 16 valve head, no problems using cutting fluid, a solid pilot, and proper technique.
blimey, I used these just after I completed my apprenticeship. All pretty space aged back then.
You can use cutting fluid to improve the finish. I didn't lap the valves in after cutting with Neway. The results were good and the engine has been running well for several years and around 60k km. The rings left by the cutter get flattened when the valve closes during use, which gives a good seal.
I prefer the tapered guide.
Please treat your tools more carefully, any damage can decrease their effectiveness.
I picked up a second hand set with a couple of cutters for around £120. Only had a 45 degree that would fit inlet and exhaust. Have priced up a 30 and 60 degree from Neway (sometimes on eBay). Did a test cut ok but could do with the two handed rotating adaptor to ensure better concentricity.
I would like to get of this
Como conseguir essa ferramenta de retificar sed de válvula ? Moro em Teresina piaui
onde compro esse kit pra envio a brasil
Are there cheap knock-offs that can have Neway cutters installed? I'm sure the center rods are important too
You might be able to find something on ebay
Hi teacher
All engine are same are 3 angles?
not all the same
Saan tayo maka order nito
Hallo sir, i want to ask what number do you use in this one box?
Custa quanto um quite desse?
you can find them on ebay from 30 dollars each
How to order this
look at ebay or google search neway valve seat cutters
Sao mình có thể mua đc sản phẩm trên
check out ebay
Where can we order it?
ebay
Hi
How and where to get purchase it
Ebay. Expect to pay over $600 for a near complete set as shown.
You can get new ones from Cylinder Head Supply. They are a bit expensive and they work really well in my somewhat limited experience. I’ve done three cylinder heads with my set.
Yah tools Hamen order karna hai
Hello bhai