We install some very nice suspension parts from Trick Chassis and Tick Performance on the Camaro

In this episode we install some adjustable torque boxes from Tick Performance. Since the rear end has been upgraded and has a back brace the TRZ anti-roll bar would not work so we found a nice anti-roll bar kit from Trick Chassis and install it as well.

[@v8tergt653]

Very nice work!! Love the outcome. One question, On what wire does the Diode come so the fan, tb, wp etc doesn’t back feed to the ECU?

[@kbern88]

The diodes go on the wires going to the output wires coming from the ecu. The diodes are one way so make sure they are the correct direction.

[@v8tergt653]

@@kbern88 Are you setting up the ECU to activate them? I just have a termi and have my Switch panel just activating a 12volt signal from the switch to the relays.

[@kbern88]

@v8tergt653 Yes, the ECM is controlling all of those items but we can also turn them on with the switch panel. We started out just using the swtch panel but after a few times of forgetting we decided to let the ecm do those functions for us.

[@v8tergt653]

@@kbern88 Yea that makes sense, thanks for the reply, greatly appreciated

[@1995trans1]

I have the same rear end and I had the perches added in the stock location for the roll bar. Do you know if the perches for the anit roll are in the stick locations ? I know you welded these on . Just trying to figure out if this will work for me without cutting off the ones i jave now. Thanks

[@kbern88]

They might very well work. I bet you could ask Trick chassis for the measurement to be sure. I think they are in the stock location but they look longer to me then the stock sway bar mounts.

[@1995trans1]

@kbern88 Thanks for the reply the video was helpful.

[@juanvillanueva5187]

What is this going to improve now

[@kbern88]

I adds extra angle to help with launching the car when racing.