Hello, I have a few questions regarding thermal and harmonic analysis of a part in Ansys. My first question is, I will keep it at 23°C for 1 hour. Then I will reduce it by 3°C per minute and wait for it to reach -60°C. When it reaches -60°C, I have to keep it at this temperature for 2 hours. Then I will increase it by 3°C per minute and wait for it to reach 23°C. I will keep it at 23°C for 2 hours. My second question is that I will need to keep the relevant part in a 90% humidity environment at 30°C for 1 hour, and at 50°C in a 95% environment for 3 hours. My 3rd question is that I will subject the relevant part to 3g peak-to-peak simple harmonic analysis from 10 Hz to 60 Hz in every 3 axes for 10 minutes. How do I do this type of work in Ansys workbench ? Can you make an example application? Thank you for your answer, best regards
Hello, For this much temperature change and duration its better if you do the thermal analysis in Fluent instead of workbench. Also it will take a lot of computing power for time range in hours. Afterwords you can use the same model for Harmonic analysis in workbench. I will try to upload a similar demo case soon. Thank you, Keep supporting 🤗🙌
sir what is the reason to take 10 different bodies in the centre line, can we move our point source at a constant temp throughout the whole length ?
I want to put many particles heat sources (each at 700K temp) inside a solid cylinder. Which steps I should take?
Hello,
I have a few questions regarding thermal and harmonic analysis of a part in Ansys.
My first question is, I will keep it at 23°C for 1 hour. Then I will reduce it by 3°C per minute and wait for it to reach -60°C. When it reaches -60°C, I have to keep it at this temperature for 2 hours. Then I will increase it by 3°C per minute and wait for it to reach 23°C. I will keep it at 23°C for 2 hours.
My second question is that I will need to keep the relevant part in a 90% humidity environment at 30°C for 1 hour, and at 50°C in a 95% environment for 3 hours.
My 3rd question is that I will subject the relevant part to 3g peak-to-peak simple harmonic analysis from 10 Hz to 60 Hz in every 3 axes for 10 minutes.
How do I do this type of work in Ansys workbench ? Can you make an example application?
Thank you for your answer, best regards
Hello,
For this much temperature change and duration its better if you do the thermal analysis in Fluent instead of workbench. Also it will take a lot of computing power for time range in hours.
Afterwords you can use the same model for Harmonic analysis in workbench. I will try to upload a similar demo case soon.
Thank you, Keep supporting 🤗🙌
Hello sir, can you give the information how create the geometry model?
Yes sure, I will create a separate video on geometry creation for this model.
very nice video
Thank you..keep supporting 🤗😊
👏👏👏👏
🤗🤗🤗🤗
Ок😊