Elektroniikan perusteet: Juotostilanteita (kolvaus, soldering)

แชร์
ฝัง
  • เผยแพร่เมื่อ 12 ก.ย. 2024
  • Skrolli 2019.1 - skrolli.fi/num...
    Video: Jarkko Lehti

ความคิดเห็น • 6

  • @dreamofeternalhappiness8001
    @dreamofeternalhappiness8001 10 หลายเดือนก่อน

    🙇‍♂️ Oi kiitos vanha viisas Väinämöinen. Videosi ansiosta löysin Skrolli-lehden ja kanavan. Juotosohjeetkin ovat hyödyllisiä. Jos haluan tehdä oman Raspberry Pi kannettavan, minun pitää oppia juottamaan näppäimistö.

  • @strannik8234
    @strannik8234 3 ปีที่แล้ว +2

    Sorry, but I will allow myself to notice a few errors.
    1. Soldering 5:19-5:51 contains a clear error where one end of the component is cold-soldered because it is simply "inserted" into the molten solder that could not be absorbed properly into the surface of the leads without the use of flux. In reality, such contact will break much earlier than others (normally sealed);
    2. Regarding the removal of solder from the landfill with the help of a braid, it can be seen that the solder is not easily removed. This is also due to the absence of flux (if the braid is already impregnated with it, then apparently this is not enough).

  • @jmtikka
    @jmtikka 5 ปีที่แล้ว +4

    Sitähän se Louis Rossmankin aina sanoo, että ei sen taidetta tarvitse olla. Tärkeintä on, että laite toimii. :-)

  • @juhani6307
    @juhani6307 ปีที่แล้ว +1

    Mitä elektroniikan perusteiden kirjaa suosittelisit aloittelijalle/harrastajalle?

  • @KaitsuMaitsu
    @KaitsuMaitsu ปีที่แล้ว

    👍👍

  • @Tunturipaaryna
    @Tunturipaaryna ปีที่แล้ว +1

    Tää jeesasi ihan perkeleesti. Näin ku ekaa kertaa olen juottamassa mitään. Toivottavasti on laitteessa pian uusi hdmi portti 🤔🙃👍 kyl tää tästä. Tää imunauha selkeytti asian mitä meitin