Flysky MultiProtocol Mod // Bind E88pro receivers on your Flysky FS-i6X !!!!!!

Subscrib the Mechaanik ‪@me.mechanik‬
Hello Friend, In this video I am going to show you how to make a multiprotocol module using Arduino Pro Mini - ATMEGA 328P - AU 5V -16Mhz nano and NRF24L01+ Pa + Lna Wireless Transceiver Multi-channel Power Amplifier Communication Module. There are such receivers that you can't bind directly to 6ch or 10ch 2.4Ghz transmitter (Flysky, Frsky and others). By this module it is possible to bind with almost all receivers. I used NRF24L01 that has low range, but you can use NRF24L01 PA+LNA for long range. I have used E88pro flight controller to bind so it is compatible with almost all transmitters using this multiprotocol module. Using this module you can easily bind Eachine, JJRC , whoop Lite and E88pro type flight controller toy drones and I hope you have Like this video.
Thanks for Watching!
#trending
#viral
Binding Operation:
1. Power on your receiver, and set it to binding mode.
2. Hold and press the bind button of RF module, and then turn on it, after 2 seconds, release the button, you will see the green light flashing rapidly, then RF module is in binding mode, and the green light will go solid after binding.
3. Some protocols (eg: S-FHSS) don’t have binding procedure on RF module, and some protocols (eg: hubsan, e010)will auto bind when power up.
Charging Operation:
1. Turn the protocol switch to“0“, power off RF module, then connect RF module to an USB charger (or other USB power supply) using Micro USB wire (not include), the status indicator will turn red while charging, and the red light will be off when charging is done.
2. RF module will always work when connect to USB power, no matter the power switch is on or off, but battery will be charged only when power switch is off.
About Protocols:
This module is based on ATmega328P microcontroller, There are 15 different protocols mapping To the 16-position protocol selection switch on the module. They are listed in the default protocols table on the last page, and You can customize these when you compile you own firmware.
#aerialphotography
#drone
#360camera
#flightcontroller
#brushless
#bldcmotor
#brushlessmotor
#digital
#rc
#amzing
#flipkart
#gimbal
#gimbalunboxing
#unboxingdrone
#esc
#flysky
#rcplane
#rcdrone
#digitalmarketing
#motor
#simon
#redyproject
#redymade
#allibaba
#bldcceilingfan
#bldcfan
#brushmakingmachine
#quadrobics
#quadcopter
#flyskydive
#fpv
#fpvdrone
#freestyledrone
#frame
#body
#propeller
#reciver
#transformers
#transmettre

[@RakshitGupta6661]

सर आप मुझे एक बनाकर भेज सकते हैं मैं आपको पेमेंट कर दूंगा

[@shantidevivbinnhi719]

Is pcb ka link daliye

[@Mr.me3001]

Bhai E88 ka protocol toh nahi hai usme. Toh phir supported protocols ke andar uska naam rakhkar kuch nahi hoga na ??

[@user-qv7ee9kb5y]

Hlo bro agar hame fly Sky ka receiver connection karna ho tho hoga ya nhi without removing this multiprotocol circuit board

[@me.mechanik]

yes friend hoga multiprotocol device ka +ve ko switch s denahoga aur jab flysky transmitter use hoga tub switch off karna prega