You installed the wire spool incorrectly; the wire should exit the bottom of the spool providing better alignment with the cable housing. If you review your welding in this video you will notice that sometimes the weld sputters but most of the time it doesn’t I think if you flip the spool over you will notice smoother and more consistent starts. Hope this helps and keep up the great videos!
Typically, the best place to seam is where the seam is the most narrow. Have you seen my truck aperture replacement video on a dodge ram? Might be helpful!
USE COUPON CODE (ABT2024) for 5% off
Shop ARCCAPTAIN www.arccaptain.com/?ref=ABT2024
Should I compare it to the GYS Auto Pulse?
You installed the wire spool incorrectly; the wire should exit the bottom of the spool providing better alignment with the cable housing.
If you review your welding in this video you will notice that sometimes the weld sputters but most of the time it doesn’t I think if you flip the spool over you will notice smoother and more consistent starts.
Hope this helps and keep up the great videos!
Thanks for that! makes so much sense!
Thank a lot for the info🙏
@@shenerdurmush3537 you're welcome!
I have the Tig 200. It works fine
Nice! I would like to learn Tig. Would you recommend it?
Absolutely, Tig is kinda like brazing. Total control.
Very good!
Did you use gas or gasless? If gas what you using? Appreciate the help 🙏
@@calumboshoff the gas is ferroline x2
What wire and thickness were you using and do you mind sharing settings? Struggling with my setup.
@calumleeboshoff9710 it's a 8mm wire and the lowest settings. Check here 1:39
🔥 🔥 🔥
Where's the best place to seam an S-10 cab corner. The patch panel is 16" top to bottom
Typically, the best place to seam is where the seam is the most narrow. Have you seen my truck aperture replacement video on a dodge ram? Might be helpful!
That thing has a spot weld function how about showing us some spot welds!
So much less than a Miller or Lincoln
These clowns making TH-cam viedos while on the clock is hilarious! Bruh dont you have work to do? 😂
Heard of flat rate? I'm on my own time, haha 😄
Who's the actual clown, the one who made it or the one who watched it? 🤣
Keep the videos coming man I like this content if I can save a 1k on a welder why not... 🎉
I'm his boss and I'm ok with it, you should concern yourself with when the fries are ready at Mcdonalds where you're working.
@@matt0wns 🍟🍟🍟😂