How to Replace Alternator 2010-2015 Lexus RX350

แชร์
ฝัง
  • เผยแพร่เมื่อ 29 พ.ย. 2024
  • Shop for New Auto Parts at 1AAuto.com trq.video/c-69-a6
    This video shows you how to install a new alternator engineered specifically for your 2010-2015 Lexus RX350. The alternator in your vehicle powers the battery and electrical system while the engine is running. If your alternator is failing, you may wind up with a constantly draining battery.
    This repair was done on a 2013 Lexus RX350 Base 3.5L Sport Utility 4-Door and the process should be similar on the following vehicles:
    2010 Lexus RX350
    2011 Lexus RX350
    2012 Lexus RX350
    2013 Lexus RX350
    2014 Lexus RX350
    2015 Lexus RX350
    Tools you will need:
    • Pry Bar trq.video/oXb-...
    • 10mm Socket trq.video/obiT...
    • 12mm Socket trq.video/obDS...
    • 14mm Socket trq.video/obDS...
    • 17mm Socket trq.video/obDS...
    • 20mm Socket
    • Pliers
    • 1/4 Inch Ratchet trq.video/obiT...
    • 3/8 Inch Drive Ratchet trq.video/obDS...
    • Torque Wrench trq.video/oaLS...
    • Gloves trq.video/oamt...
    • Safety Glasses
    • Drain Pan
    • Floor Jack trq.video/oabc...
    • Jack Stands trq.video/oYe-...
    • Pick trq.video/oSj-...
    • Wheel Chocks
    Subscribe: / @trq
    Check out our playlist:
    Lexus RX350 2nd Generation 2010-2015: • Lexus RX350 2nd Genera...
    ⚠ DISCLAIMER:
    While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

ความคิดเห็น • 15

  • @TRQ
    @TRQ  ปีที่แล้ว +3

    √ Watch the Video
    √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
    √ Do it Yourself
    √ Save Money

  • @tomv.5083
    @tomv.5083 4 หลายเดือนก่อน +6

    Local mechanic told me the book says it takes 7 hours to do this job. He wanted $750.00 just for labor. I ended up doing it myself in 2 hours. Thank you for the video.

  • @RJGRAHAM
    @RJGRAHAM 8 หลายเดือนก่อน +10

    I just did my 2010. You don't have to remove any of the front end bumper or grill or radiator. I just took out the fan assembly and it came out fine. The alternator bracket that is hidden you can use a mirror and line up the 12mm socket from the top and get that out. Then wiggle the alt out enough to get to the 12mm bolt on the alternator and remove the bracket. Throw that POS out. All it does is hold a wire, complete waste. It is not used on any other Toyota 3.5. Don't take the belt off either unless you are replacing it. Just slide it off the alternator pulley and leave the rest on. Make sure you have a long ratchet to get that bottom bolt out to clear the pulleys and give you a grip on it to break it free. A long breaker bar may work also. You just need the length.

  • @tomlavin1603
    @tomlavin1603 ปีที่แล้ว +9

    Holy Crap, why does Toyota make that so frickin hard?

  • @canada-wonq
    @canada-wonq 10 หลายเดือนก่อน +2

    I tried 2010 rx350.
    It doesn't need to remove bumper. You can remove grill instead that gonna be easier.
    Anyway, this is great video that I was really helpful for job. Thanks😊😊

  • @ghostfacehd5333
    @ghostfacehd5333 9 หลายเดือนก่อน +3

    Your going to lead ppl down a dark path….

  • @canada-wonq
    @canada-wonq 9 หลายเดือนก่อน +2

    16:53
    After remove bracket bolt from alternator, you should detached wire harness (that connects crank shaft position sensor) from the bracket. I removed without this job and wire harness was disconnected so I had to replace wire and plus compressor job. This video is not suitable for beginners and you should be careful.

  • @zhudongming6289
    @zhudongming6289 5 หลายเดือนก่อน +1

    Great video,Thanks

  • @davidfrankel5301
    @davidfrankel5301 2 หลายเดือนก่อน

    PSP on your diagram is not a Power Steering Pump. The car has electric steering. It does have an AC Compressor and that is what PSP should say. All said.. terrific demonstration. Folks should watch it twice before attempting - especially the plastic crap. This is not your father's Oldsmobile.

  • @Unkown-1226
    @Unkown-1226 ปีที่แล้ว +1

    Why wasnt this vid posted a month ago 😭 i was struggling to change the alternator on this car

  • @anarky4321
    @anarky4321 ปีที่แล้ว

    what size is the "little bolt" ? m8 ?

  • @BigDipper79
    @BigDipper79 11 หลายเดือนก่อน

    You do not have to remove the bumper to do this. I’ve done this twice.

    • @TRQ
      @TRQ  11 หลายเดือนก่อน +1

      +@BigDipper79 We appreciate the feedback. Sometimes there are multiple ways to accomplish the same repair. 1aau.to/m/Shop-TRQ

  • @VPBOYZ904
    @VPBOYZ904 6 หลายเดือนก่อน

    Replacing an alternator on this car is harder than replacing the starter 😔🤦‍♂️

  • @KerisianoAiga
    @KerisianoAiga 3 หลายเดือนก่อน +1

    So many fkn steps why