1948 John Deere B Part 14 Restoration - Governor and Fan Shaft Assembly

แชร์
ฝัง
  • เผยแพร่เมื่อ 8 ธ.ค. 2024

ความคิดเห็น • 7

  • @Kalkaekie
    @Kalkaekie 3 ปีที่แล้ว

    Good video !!

  • @johnlambert3360
    @johnlambert3360 4 ปีที่แล้ว +1

    Daniel, how did you put the large bevel gear back on the shaft and align it with the key? Did you heat the gear first?

    • @DanielFarmChannel
      @DanielFarmChannel  4 ปีที่แล้ว +2

      I didn't have to heat anything. Using a press allows for slow and controlled assembly. Just line it up as best you can when you start to put it on. If it isn't lined up enough press it off and try again.

  • @earlerickard2046
    @earlerickard2046 3 ปีที่แล้ว

    Does the outboard end of the fan shaft need to be shimmed up or down to keep it in proper alignment?

    • @DanielFarmChannel
      @DanielFarmChannel  3 ปีที่แล้ว

      The system isn't designed with any shims where the support sits on the frame, so no. Interesting and great question though.

  • @Marine-72
    @Marine-72 ปีที่แล้ว

    Dumb question, but how are the governor gears lubricated?

    • @DanielFarmChannel
      @DanielFarmChannel  ปีที่แล้ว +1

      On the back side of the casting is a hole that lines up with a hole in the main case. Oil is pumped up through that hole and that is fed onto one of the bearings or shaft, I forget. It is then splash fed to everything else.