Rapid Review: Amazon Generic UTV Turn Signal Kit

Low cost UTV turn signal kit on Amazon
www.amazon.com...
The brackets were not included. I made them from scrap material I had.
I also used this 1/4" split loom tubing.
www.amazon.com...

[@davidgriego3479]

I bought the same kit , I'm not the best at wiring. How do you connect them all to work?

[@AZTMCS]

Hopefully you got the wiring diagram. You can connect either ignition 12 volts or battery 12 volts to the flasher. If you use battery power, just know that if you leave the signals on, you can run down the batter. The ground will be common to the flasher, switch and the red and orange lights. I used the frame for ground. As a test, connect one of the lights to the signal switch (you can just twist the bare wires together, make sure the ground is connected to everything), apply power to the flasher and the light will flash. If not, then change the switch position to the other direction. Mark the wire from the switch, noting which direction activated the light. This will tell you which wire from the switch is left or right. Next you'll have to run wire from the switch to both the front and back of the machine, to where you want the lights. Connect both front and back positive wires to the wire from the switch for that side. The red wire is positive on the red light, the yellow wire is positive on the orange light. Hope that helps.

[@davidgriego3479]

@AZTMCS thank you helps out alot