How to Replace Cup Holder 2008-2010 Ford F-250

Buy Now!
New Cup Holder from 1AAuto.com 1aau.to/ia/1AIMX00231
This video shows you how to install a cup holder on your 2008-2010 Ford F-250.
This process should be similar on the following vehicles:
2008 Ford F-250 Super Duty
2009 Ford F-250 Super Duty
2010 Ford F-250 Super Duty
Tools you will need:
• Phillips Head Screwdriver 1aau.to/oa7L/1AXAA00013
• 7mm Socket 1aau.to/oaSg/1AXAA00017
• Trim Tool Set 1aau.to/oYH/1AXXX00006
• Ratchet 1aau.to/obkY/1AXAA00016
• Socket Extensions 1aau.to/oban/1AXAA00015
• Swivel
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@alanperkins7424]

Thanks for the very clear demonstration, whew, what a pain.

[@alanperkins7424]

Very nicely done. I just finished replacing the cup holder successfully thanks to this video. Thank you.

[@victorioussmiles5958]

2008 Ford f250 super duty 5.4l,,,,done perfect fit.
Thanks for the video.

[@ksich8142]

This guy scratched everything 😂

[@christiank696]

Pretty sure you can just remove the two screws in the cup holder and use a butter knife to press the tab down. Should pull right out after that

[@Krazyhunter]

Why are you tearing the dash apart if you don't have to? Open tray, remove 2 screws, pop the 2 tabs on the sides so you can pull bottom of tray out, now you have access to hinge pin, drive pin out with awl, or long skinny phillips screw driver, do everything in reverse and done in 10 minutes at most. your welcome.

[@TRQ]

+My Alaskan Adventure We appreciate the feedback. Sometimes there are multiple ways to accomplish the same repair. 1aau.to/m/Shop-TRQ

[@mg-iw6hw]

You could short cut removal and installation per this video
th-cam.com/video/1EhzbPGaubU/w-d-xo.html
although your video finished the removal and installation of the cup holder.
Thank you.