Thanks a lot! My cruise control works again. The worst part of the job is definitely access to this switch. Also. The cable connected into it is very short so I needed to dive in entirely under the steering wheel to get this sorted. However. It took me around half an hour to get the old one out, but just a minute to put the new one back. What I found is when you pull the red plastic up, then the side teeth are unlocked and you do not need to push so much to fit this little thing to the frame. It is just come in very easy, and you can hear the click while its fitted. Thanks again
Also to remove the light switch easily you push the knob in and turn right (turning them on) and it pushes the tabs in and locks them in place allowing you to pull them out. Then to reinstall just put them in enough, turn left (turn them off) and then push in until you hear it lock in place again
Great Tutorial! I want to install cruise control stalk, because now I don't have. I don't have clutch switch, but do I need it, I mean can I install and activate cruise control without that switch? I guess this is if I want to change gears, but if I drive on the highway I don't need clutch switch. Am I right ?
Great tutorial! The cruise control on a 2006 Zafira doesn't work, there are no codes and the fuse is fine. Hopefully changing this switch will fix the problem. Thanks
You all probably dont care at all but does someone know a tool to log back into an Instagram account?? I was dumb lost my password. I would love any help you can offer me.
@Marshall Zane thanks for your reply. I got to the site through google and im trying it out now. Seems to take quite some time so I will get back to you later with my results.
Hi no you don't have to touch the battery and error message never appeared on dashboard . I plugged computer to check the errors ,afeter replacement it's working again if you do that by your self make sure the ignition is switched off thanks
Sir, is it mandatory to remove lower part of the dash board to remove clutch switch. I can hear click-click in my Astra H when pressing clutch pedal. This annoying sound comes from inside the cabin. My car has good acceleration, power and have no issue with changing gear.
Hi yes in vectra I have full plastic cover, under steering wheel ,it helps you to have easiest access to the switch .make sure is that what make noise cause could be a clutch pedal spring all the best
If the fault light illuminates whilst the engine is running, this signifies a fault within the engine or gearbox electronics system. The system will switch to emergency mode where fuel consumption may increase and the vehicles drivability reduced. If the light flashes whilst the engine is running, this signifies a fault within the electronic immobiliser system and the engine will not be able to be restarted. That is full explanation from vauxhall I hope it helps
you can buy this on ebay or go to any car parts shop www.mister-auto.co.uk/en/switch-clutch-control/facet-7-1207_g2415_a1597.1207.html that is another place
well it depend what make cruise control faulty could be sensor,or switch stalk handle control and other things best way is to plug in diagnostic computer
Hi I've never dealt with the corsa but you need to check when you press the clutch is it touch the connecting switch....if it is the switch could be faulty but a computer diagnosis would tell you
Why is that? I want to change it on a Corsa D 2010, but I could not get it out. Had the red piece forward (which should loose the clips) but it did not move at all. Is there some tricky thing that I might not know?
![[Zrób to sam] Naprawiam tempomat w Opel Vectra C - Andrzeja MOTO Świat #12](http://i.ytimg.com/vi/joiTcLndq_g/mqdefault.jpg)
Thanks a lot! My cruise control works again. The worst part of the job is definitely access to this switch. Also. The cable connected into it is very short so I needed to dive in entirely under the steering wheel to get this sorted. However. It took me around half an hour to get the old one out, but just a minute to put the new one back. What I found is when you pull the red plastic up, then the side teeth are unlocked and you do not need to push so much to fit this little thing to the frame. It is just come in very easy, and you can hear the click while its fitted. Thanks again
yeah.. he he I had to dive as well ... glad is sorted
if you pull the red part forward the clips will slide in to the mount easier (allows them to move in) then push the red part back down once into place
great tutorial ..easy to follow and I hope easy to do ...thanks again
Thanks
Aunque no he entendido nada, he aprendido de tus movimientos.Gracias.Un saludo.
Lo video es del mi esposo.esta contento qi ajudo a uste asta qi no entendiste. Gracias
Also to remove the light switch easily you push the knob in and turn right (turning them on) and it pushes the tabs in and locks them in place allowing you to pull them out. Then to reinstall just put them in enough, turn left (turn them off) and then push in until you hear it lock in place again
Bennie Bounce nobody seems to know but its so simple
before replacing it try to adjust it. You can do that by pulling the black stick out. It is adjustible.
Thank you fantastic I had my heater matrix fix and have lost my CC this maybe the reason why..
You have the pull the red tab forward so that clicks in I broke mine trying to force it
before replacing it try to adjust it. You can do that by pulling the black stick out. It is adjustible.
Legend 👌
Great Tutorial! I want to install cruise control stalk, because now I don't have. I don't have clutch switch, but do I need it, I mean can I install and activate cruise control without that switch? I guess this is if I want to change gears, but if I drive on the highway I don't need clutch switch. Am I right ?
what car you have?Model? year ? engine?
opel astra, 1,4 petrol, 90 h.p. 2008
You have to have one or some one remove before you look for the loos wire under your steering wheel
I dont have Cruise controls and i want to install, where can i find a wires for the clutch switch?
Great tutorial! The cruise control on a 2006 Zafira doesn't work, there are no codes and the fuse is fine. Hopefully changing this switch will fix the problem. Thanks
You all probably dont care at all but does someone know a tool to log back into an Instagram account??
I was dumb lost my password. I would love any help you can offer me.
@Lane Shane Instablaster =)
@Marshall Zane thanks for your reply. I got to the site through google and im trying it out now.
Seems to take quite some time so I will get back to you later with my results.
@Marshall Zane It worked and I now got access to my account again. I am so happy!
Thanks so much, you saved my ass :D
@Lane Shane You are welcome :)
thanks! :D
Hi, thanks for the tutorial. Did you needed to switch off the battery cables? Did the error messages disapeared? Hug
Hi no you don't have to touch the battery and error message never appeared on dashboard . I plugged computer to check the errors ,afeter replacement it's working again if you do that by your self make sure the ignition is switched off thanks
Sir, is it mandatory to remove lower part of the dash board to remove clutch switch.
I can hear click-click in my Astra H when pressing clutch pedal. This annoying sound comes from inside the cabin.
My car has good acceleration, power and have no issue with changing gear.
Hi yes in vectra I have full plastic cover, under steering wheel ,it helps you to have easiest access to the switch .make sure is that what make noise cause could be a clutch pedal spring all the best
Can I use WD-40 for the first help ?
Sometimes I hear click-click, sometimes not.
ye you can try but not to much
on my astra h 1.4 2008 90 hp / cv / bhp does he have clutch switch?
www.ebay.co.uk/itm/Vauxhall-ASTRA-AGILA-CORSA-MERIVA-TIGRA-VECTRA-ZAFIRA-CLUTCH-PEDAL-SWITCH-NEW-/311382320878?hash=item487fd526ee:g:BZcAAOSw3xJVfunA
How do you remove the switch
Is it possible that car and spanner signal is appearing on dashboard because of the clutch switch fault ?
If the fault light illuminates whilst the engine is running, this signifies a fault within the engine or gearbox electronics system. The system will switch to emergency mode where fuel consumption may increase and the vehicles drivability reduced. If the light flashes whilst the engine is running, this signifies a fault within the electronic immobiliser system and the engine will not be able to be restarted. That is full explanation from vauxhall I hope it helps
Clutch switch is not connected to dashboard system you have to plugin computer and read the fault's
@@stanlej81 that's what I needed to know👍🏾thanks
Corsa cruise control not working could it be this switch?
Yes high possibility but best way is plug in computer to make sure
on my astra h 1.4 2008 90 hp / cv / bhp does he have clutch switch?
you can buy this on ebay or go to any car parts shop www.mister-auto.co.uk/en/switch-clutch-control/facet-7-1207_g2415_a1597.1207.html that is another place
well it depend what make cruise control faulty could be sensor,or switch stalk handle control and other things best way is to plug in diagnostic computer
ok.. and what if its an automatic, that has a faulty cruise control? :DDD
Hi. I have a corsa d 2011 1.3 diesel. It both has start stop and cruise control. Start stop works but cruise control doesn't.. Is it the same switch.?
Hi I've never dealt with the corsa but you need to check when you press the clutch is it touch the connecting switch....if it is the switch could be faulty but a computer diagnosis would tell you
Hello..can someone help me. I have astra H 2005 tempomat don't work... On diagnostic no errors.. can someone tell me what is the problem?
don’t try this on a corsa D, impossible without taking out the steering assembly
Why is that? I want to change it on a Corsa D 2010, but I could not get it out. Had the red piece forward (which should loose the clips) but it did not move at all. Is there some tricky thing that I might not know?