Very nice vid with usefull info. Just a comment when doing the paper trick: when lowering the nozzel @ 0.5mm increments and starts holding the paper, change to 0.1mm! I didnt and forced the nozzel onto the builtplate causing a little pin dent but bigger issue was the nozzle' hole got slightly damaged causing the extruded filament to curl.
If you "tune" your belts it'll take those spikes down even more. Had a similar mesh on my sr until about a week ago. I "tuned" the belts to 60Hz with a piano tuner app and it took my mesh variance from .6-ish to .23
If you now print on that after you flip it back to the other side your mesh is out because you have flipped it. Doesn't matter its a circle as you still have flipped it and now the two halves of the circle have swapped and now your measurements will be out ! Your thinking how can that make any difference. If there is inconsistencies on one half of the build sheet it will be enough to make a difference; I be doing my mesh again. Not sure what people are thinking suggesting doing that. ! 9x9 grid is a great idea and some do suggest the 5 verses 3 measurements is better. I generally get a good first layer on my v 400 but I am looking to change to a 9x9 grid. Thank you for the video.
![CAMPปลิ้น | EP.76[1/2] โจโฉเปิดป่าโหดรับโอ๊ต-ป๊อบ รอบนี้พี่เอาจริง!](http://i.ytimg.com/vi/pNg5O7Pf-a0/mqdefault.jpg)
![Yoshi Rinrada - 'มาทำไม' [Official MV]](http://i.ytimg.com/vi/r41xbfRLkLs/mqdefault.jpg)
Great video!
Very nice vid with usefull info. Just a comment when doing the paper trick: when lowering the nozzel @ 0.5mm increments and starts holding the paper, change to 0.1mm! I didnt and forced the nozzel onto the builtplate causing a little pin dent but bigger issue was the nozzle' hole got slightly damaged causing the extruded filament to curl.
Seen similar video. Done same steps as you did
If you "tune" your belts it'll take those spikes down even more. Had a similar mesh on my sr until about a week ago. I "tuned" the belts to 60Hz with a piano tuner app and it took my mesh variance from .6-ish to .23
If you now print on that after you flip it back to the other side your mesh is out because you have flipped it. Doesn't matter its a circle as you still have flipped it and now the two halves of the circle have swapped and now your measurements will be out ! Your thinking how can that make any difference. If there is inconsistencies on one half of the build sheet it will be enough to make a difference; I be doing my mesh again. Not sure what people are thinking suggesting doing that. !
9x9 grid is a great idea and some do suggest the 5 verses 3 measurements is better. I generally get a good first layer on my v 400 but I am looking to change to a 9x9 grid. Thank you for the video.
Is this a brand new one or one of the $400.00 rebuilt ones? I've been thinking about getting one of the rebuilt ones lightspeed was talking about.