ฝัง
- เผยแพร่เมื่อ 25 เม.ย. 2020
- hallo guys, in this video how to make Awesome Mini Amplifier Circuit | Powerfull 100 Watt DC 12v
WARNING:
This video is for demonstration and education purpose only
Each demonstration presents risk and hazards that must be fully understood before attempting and should be performed only by professionals
Music:
Jim Yosef - Firfly [NCS Release]
Music provided by NoCopyrightSounds.
Watch: • Jim Yosef - Firefly | ...
#PowerfullAmplifier
#dwtech #BigBass #MiniAmplifier
#DIY - วิทยาศาสตร์และเทคโนโลยี
Buenas tardes amigo el vídeo está incompleto, no se observa dónde van los cables de la corneta y fuente. Por favor revisa ya que este proyecto está buenísimo.
Wah wah kya amplifier aur video pahili baar dekha hai
nice ¡!!!...100W rms???... 🤔
Super sound quality 😆😆
Me gusto tos proyectos
gracias
@@dwtech6777 acho quê vc tentou criar uma bomba mais não deu certo kkk 🙁😞
use 2 transistor 13007 , R1k, capacitor 47uf 16v
Very nice amplifer
Thanks
12V DC 100W? Haha! :D
Donde esta la corriente de 12 volts donde conecto los cables??? No sé ve
Si se ve el negativo de 12v es el cable café que va a la pata 2 del transistor segundo y positivo a la bocina
Itni lambi video akher m, no speaker awaz🔊👌👌👌
Correct😂😂😂
Good technology
Maaf boskuuh kurang jelas soalnya alasnya warna putih kasih warna yang kontras baru tambah ok terima kasih...
Esse apifido serve pra TV
Muito bom
1minutes nice working Very Heat Sound problem
Use heat sink
@@balalmagar7294
Thanks Sir Now Ok 💯 Working
Se puede usar 9v ?
I have a dude the transistors is npn or pnp?
Como puedo descargar este video
What was that ? Just some kar kar sound ?
Kalau di tambah colokan mic bagaimana bang?
Куда плюс, а куда минус питания??
Bhai ya audio wire ko explain kar ki ground kon si hai or left and right wire kon se hai please send me answer🙁😞🙁🙁
input audio left
Rangkaian semrawut
Fake 1 watt amplifier if that ~ ! if you are lucky
you can find a tiny speaker put it on your ear perhaps you will hear a faint sound !
12v + or speaker ka _ Kahan Lagy ga?
Supply + connected through speaker Blue wire to TIP127 Emitter for sound and power and supply -- to collector TIP 127
It's really 100watt
7 Minutos, da minha vida, foram perdidos com este vídeo... PQP mano. kkkkkkkkkkkkkkkkkkkkkkkkkk
kkkk eu queria saber o motivo dele ter postado
acho quê ele tentou criar uma bomba mais não deu certo kkk
12v chưa rõ
Konten berisi Amplifier,,
Thumhari sari video like kar do ga
Why Tip 127 hevy heat.
klo resitor tip sama gmn ka
Or suscribe bhi
kkkkkkk pane no sistema....meidei meidei kkkkk acho quê ele tentou criar uma bomba mais não deu certo kkk
só em ele sodar o segundo transistor eu vi q ia da merda
ESO NO DA NI DIO 100W...
Bad design, running DC thru the speaker will blow it.
Explain car audio coming from a DC battery.
It doesn't go through a rectifier to convert it to AC as that would damage all other internal components
@@cooperradke3774 Push-Pull amplifier with single power supply must have a coupling capacitor to isolate dc from speaker. In your design you connect one side of the speaker directly to the positive of the battery.
Polarization of the transistors is done because of dc passing through the speaker and that is very bad. In car radio, the speaker is connected between two push-pull amplifier with a phase difference of 180 degrees between them.
Cómo crear un electropedo
Please answer my question
No muestra bien al final del vídeo
6:49 AHAHHAHAAHAHAH
please charge mobile
Estuve viendo el vídeo asta el último y el circuito no sirvió
Perdida de tiempo viendo ese video le tiembla la mano y no sabe ni soldar
kkk
acho quê ele tentou criar uma bomba mais não deu certo kkk
7.1 minutes of non-sence video!
acho quê ele tentou criar uma bomba mais não deu certo kkk
It didn't work in the end. What a waste of time.
Bohoti baker ar fake hai yea idiea.😠😠😠😠😠😠😠😠😠😱
Nmms no sirvió esta mamada JAJAJA 7 minutos de tiempo perdidos
Bal
Thank you for wasting my time