How To Replace KZ400 Points (Presidential Fly Over Included!!)

แชร์
ฝัง
  • เผยแพร่เมื่อ 22 ส.ค. 2024

ความคิดเห็น • 11

  • @crabtrap
    @crabtrap 4 ปีที่แล้ว +1

    thanks dude! i couldn't get spark on my 76 KZ 400. i know it was the point but couldn't figure out the condenser and 12vt blue wire placement on the points n base. after your vid i get her fired on start fluid first time in 12yrs of sitting in old shed; thank God i drained the gas and carbs 12yrs ago! Kawasaki lets the good time roll!

  • @mclovinfromhawaii8914
    @mclovinfromhawaii8914 4 ปีที่แล้ว +2

    What was the kit you used?

  • @noonereallynose
    @noonereallynose 2 ปีที่แล้ว

    Hey so I just got one of these and the was wrecked and I want to know if the engine is good but the wreck messed up a lot of the wiring and I was wondering what is the basic wiring I need to check for spark

  • @jubileeflymusic
    @jubileeflymusic 4 ปีที่แล้ว

    Hey, thanks for this vid! I have the same cycle. Where did u put the lube?

  • @tatewillprecht2638
    @tatewillprecht2638 2 ปีที่แล้ว

    I just got one of these and need to install a coil but don’t know where the wires go could u make a video on this

    • @TheSOMotorsports
      @TheSOMotorsports  2 ปีที่แล้ว

      The coil is under the gas tank. One wire comes up from the points area to the coil, it only fits in 1 spot, then the coil outputs to the spark plugs.

  • @EVO3snowboarding
    @EVO3snowboarding 4 ปีที่แล้ว

    Would this fix a problem of sputtering and backfiring at 35mph+? I just picked up a 76 kz400 and this is the first thing the previous owner recommended

    • @TheSOMotorsports
      @TheSOMotorsports  4 ปีที่แล้ว

      This fixed a no-spark issue for me, and really that's what it does, makes sure there is spark. If its sputtering check fuel filters and carbs, then check something like timing. If it is running up to 35 then it is obviously getting spark

  • @TuroG
    @TuroG 3 ปีที่แล้ว

    Where did you buy the kit

  • @Slash_SAL
    @Slash_SAL 3 ปีที่แล้ว

    This isn't the correct way of doing it. It needs to be adjusted after installing.

    • @TheSOMotorsports
      @TheSOMotorsports  3 ปีที่แล้ว

      Yes I stated that it will need to be gapped/timed around the 8 minute mark.