Can changing the front tranny mount throw the alignment of the shifter off? As after installing a rebuilt engine and new clutch cable on my 67 bus along with the tranny mount the shifter is grinding going into reverse, like its not going far enough into gear and when it is and when I let up on the clutch it just pops out of gear which feels like it was barely in. And I thought that maybe I didn't have the clutch cable not tight enough but after tighting it down a little more its still the same. Hmm?
Do you still have this shifter and from a scale to 1/10 what would you rate the t shifter ? I know this video is very old but would like to know the review on this because no other video on TH-cam has a review video of that shifter so if you read this can you please respond would really mean a lot
This is a older post I know, but "YES", there is a nylon bushing inside the hole towards the engine. I would bet over 60% or more are bad on cars. Just a bad design. If your sifter is clanking or it sounds like its hitting metal, the bushing is bad and don't even exists anymore. Its like a $3.00 part to replace.
Thanks this video helped me out. I just bought 68' bug and I cannot change gears on 1st or reverse. Thanks again.
Grasias carnal si vieras como me ayudó tu video
Can changing the front tranny mount throw the alignment of the shifter off? As after installing a rebuilt engine and new clutch cable on my 67 bus along with the tranny mount the shifter is grinding going into reverse, like its not going far enough into gear and when it is and when I let up on the clutch it just pops out of gear which feels like it was barely in. And I thought that maybe I didn't have the clutch cable not tight enough but after tighting it down a little more its still the same. Hmm?
is the 2 tab shifter plate better than the single tab cheers
Great simple explanation on how to install and a cool video to boot! Thanks! What kind of grease did you use? Thanks again! -'72 Super
Do you still have this shifter and from a scale to 1/10 what would you rate the t shifter ?
I know this video is very old but would like to know the review on this because no other video on TH-cam has a review video of that shifter so if you read this can you please respond would really mean a lot
I got it ! Thanks !!!!
Great music! Hard driving like I treat my bugs!
If you replace the shifter do you need to do anything with the linkage and rods?
no you dont need to do anything... :) take old one out install new one :)
This is a older post I know, but "YES", there is a nylon bushing inside the hole towards the engine. I would bet over 60% or more are bad on cars. Just a bad design. If your sifter is clanking
or it sounds like its hitting metal, the bushing is bad and don't even exists anymore. Its like a $3.00 part to replace.
Finally a bit chen sound track!
Tik tik tik
this is a right side drive edition
lay off the speed