I was just about to order a new mechatronic, but found your video and figured, I may as well open the TCM to see if anything jumps out as the cause of my 18223 code. Which pressure sensor is for which solenoid? Is the one in the bottom left corner (at 0:14), first to have voltage tested in the video n215? And what's the "pin out" of the sensor's three wires? + - signal? Also, I had oil inside the cover. How does it make its way in, and how can I prevent that when reassembling? What sort of adhesive/sealant is used on the cover? Thank you for the video and any help you can offer. Might be able to save a good chunk of money.
Hi, these are my fault codes, it has attempted to be repaired by testing place and I think they replaced pressure solenoids(wouldn’t tell me what they did) but the fault still arises when gearbox gets hot, when gearbox cold it works brilliant
I was just about to order a new mechatronic, but found your video and figured, I may as well open the TCM to see if anything jumps out as the cause of my 18223 code. Which pressure sensor is for which solenoid? Is the one in the bottom left corner (at 0:14), first to have voltage tested in the video n215? And what's the "pin out" of the sensor's three wires? + - signal?
Also, I had oil inside the cover. How does it make its way in, and how can I prevent that when reassembling? What sort of adhesive/sealant is used on the cover?
Thank you for the video and any help you can offer. Might be able to save a good chunk of money.
Масло проникает через уплотнение датчиков давления!
Там резиновое кольцо с наружным диаметром 24мм и толщиной 2мм. При сборке дополнительно герметик.
Hi, these are my fault codes, it has attempted to be repaired by testing place and I think they replaced pressure solenoids(wouldn’t tell me what they did) but the fault still arises when gearbox gets hot, when gearbox cold it works brilliant
If this sensor fails does it cause oil leaks from the mechatronic connector? No error codes or issues. Just oil leaks
Привет!
У тебя уже масло внутри блока!
Под крышкой!
Чаще всего достаточно заменить уплотнительные кольца.
Я это делаю даже не отпаивая проводников!
Hi where I can buy this sensor ?
Electronic control unit pressure sensor for automatic transmission DQ250 02E DSG 6:
maktrans.net/52CP05
Does the white cover just pull off or do you need to cut it?
the white cover can be cut off or carefully removed with a special tool
Нужно отрывать с усилием и прогревом. На герметике сидит