ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
I have a jd 336 baler. There are two holes at the top of each needle. Which hole does should the twine come through (top or bottom)?
top
Where is the guide that is to the right That the Tucker finger presses the string against Is it needed with the upgrade
Tank's
مرحبا
How to synchronize it or put it on time friend?
❤❤
Would there need to be any re-timing done after replacing the assembly?
Why? Does it give me more thread on one side, like an inch or two more?
Sme z Slovenska. Kúpili sme balikovač Johann Deere. Máme veľký problém. Není tu servis na našom trhu. Náhradné diely sú strašné drahé. Mám hlavu v smútku.
I have a john deere 346 wire the left side does not tie every 15 loose bales 2 or 3
Wie stelle ich sicher, dass die Saiten nicht von Nagetieren geschnitten werden? Danke
Could you guys make a video showing how to time the plunger to knotter on a 24T?
InstaBlaster...
I have a jd 336 baler. There are two holes at the top of each needle. Which hole does should the twine come through (top or bottom)?
top
Where is the guide that is to the right That the Tucker finger presses the string against
Is it needed with the upgrade
Tank's
مرحبا
How to synchronize it or put it on time friend?
❤❤
Would there need to be any re-timing done after replacing the assembly?
Why? Does it give me more thread on one side, like an inch or two more?
Sme z Slovenska. Kúpili sme balikovač Johann Deere. Máme veľký problém. Není tu servis na našom trhu. Náhradné diely sú strašné drahé. Mám hlavu v smútku.
I have a john deere 346 wire the left side does not tie every 15 loose bales 2 or 3
Why? Does it give me more thread on one side, like an inch or two more?
Wie stelle ich sicher, dass die Saiten nicht von Nagetieren geschnitten werden? Danke
Could you guys make a video showing how to time the plunger to knotter on a 24T?
InstaBlaster...