Quick question. I have a john deere 2020 or 2010 with dual output shafts, well where i can go from 540 to a 1000 by taking the pto shaft out and dropping it below to the 10000 section. Should there be a snap ring that holds the shaft in place or is there some kind of lever on the tractor that locks it in place? Thanks.
@@MichiganFarmer. Thanks for the reply. I figured it out, a roll pin holds the shaft in place. On the PTO shaft theres holes where the PIN goes in, but first the cover plate needs to be taken off to put the pin in .
![[TH] VALORANT Champions Seoul - Group Stage Day 10 - EDG vs PRX](http://i.ytimg.com/vi/fRVt3eGibx4/mqdefault.jpg)
Love to young men like yourself so passionate about farming and the way of life. Thank you because it's not an easy life but a rewarding one.
Good little yard tractor
love to have the H. nice tractors.
I was born and raised in Jackson. Good vid 👌 👍
Might be a good idea, to check the gear oil in the bush hog, and grease it. It probably needs some TLC. 👍
My dad has one of these and it still works well. It also has a yellow roof on top.
Why is the rain cap stuck closed? It should be standing srt8 up with engine running 15:35
Nice! A little love and you will have a couple nice utility tractors.
The restored Farm All's Did you get to run those?
No I haven't yet. I believe those are being sold to a family friend who collects red
@@MichiganFarmer.
I'm personally a ""Green" guy, but they were nice looking units. 🤠
At least the tachometer works, most of them models the tachometer stop working.
Is this farm on big hand rd by chance?
Quick question. I have a john deere 2020 or 2010 with dual output shafts, well where i can go from 540 to a 1000 by taking the pto shaft out and dropping it below to the 10000 section. Should there be a snap ring that holds the shaft in place or is there some kind of lever on the tractor that locks it in place? Thanks.
@davidvamco5462 I'm not 100% sure but I doubt there's a lever. My best guess is a snap ring holding it.
@@MichiganFarmer. Thanks for the reply. I figured it out, a roll pin holds the shaft in place. On the PTO shaft theres holes where the PIN goes in, but first the cover plate needs to be taken off to put the pin in .
Krijg no diesel