Are you saying when you set your suv on the lower two lock settings, it bent the bottom plate? So its not a good idea to use those lower settings at all?
Dumb question but , were you using thee rubber blocks at your lift points in this video ? I saw one on the floor and one outside of the car on the lift.
Just got the same lift 110V , pneumatic locks , curious what amp circuit are you running? I tested it out on a 20amp and instantly tripped the breaker with no load on it.
@Drives88 thanks , I finally looked at the motor rating and came to the 30 Amp conclusion. So far been pretty happy with the lift. Thanks for making the videos helped make the decision.
Are you saying when you set your suv on the lower two lock settings, it bent the bottom plate? So its not a good idea to use those lower settings at all?
john , looking to buy same lift soon , you said you have had truck on it , could you post that , its one of the main things stopping me at this point
I regularly lift my 2018 Expedition without any issues. Next time I lift it, I'll try to remember to take a vid or pic.
I do have a pic with my explorer on it here: photos.app.goo.gl/dDX9af71xUgvhVDv7
Dumb question but , were you using thee rubber blocks at your lift points in this video ? I saw one on the floor and one outside of the car on the lift.
I have to use the 4 2" block to lift that mustang, looks like 3 were on the floor and one was on the driver side lift.
Looking at this one on ebay and it says air compressor required. Does your use an air compressor? Where did you buy your from ? Thanks for the Vid....
I also bought it off ebay. Yes it uses compressed air to release the safety locks.
Now they sell electric lock release ones but more $$$
Just got the same lift 110V , pneumatic locks , curious what amp circuit are you running? I tested it out on a 20amp and instantly tripped the breaker with no load on it.
I actually ran a 30amp 120v circuit for my welder that I ended up using for the lift. Your right, 20amp just isn't enough most of the time.
@Drives88 thanks , I finally looked at the motor rating and came to the 30 Amp conclusion. So far been pretty happy with the lift. Thanks for making the videos helped make the decision.
I have the same one and run it on a20 amp breaker no problem just make sure the lift goes up a few inches before contacting vehicle
How do you set to down button slower. Thanks
Adjust the bleeder on the pump. It’s in the manual.
@@anonymous..- thanks
Did you get it delivered to your house? Im planing to buy one soon
No I had it delivered where I work, I brought it home on a snowmobile trailer that tilts.
Did you ever order? I’m wondering if the shipping company unloads it off the freight truck
@@Joe11221-d I did but pick it up my self warehouse was about 40 min away. I picked it up on my trailer
@@5818lopser Mind if I borrow it :)
@@5818lopser Thanks for the reply.
They might 'do the job' but i don't support slave labor 😂
How high are the ceilings? How many foots ? Thanks