วีดีโอ

Bro, thanks for the video help me a lot 💪🏻💪🏻

Thanks for doing this video!

I hate to be a hater, but there are just so many things wrong here, and following this video could damage your car. First, you do not use “power steering fluid” from the parts store. As others have pointed out, you need to use GM-approved Dexron automatic transmission fluid. Yes, the manual will tell you “Dexron III”, but that’s only because GM was only on version III when the Z31 was produced. Modern Dex-VI is fully backwards compatible, plus it is synthetic so it will last and protect longer. So refill with Dexron-VI. But whatever you use needs to be RED not clear. There is a filter in the top of the reservoir. You need to remove it so you can really get down into the tank and pull as much old fluid out as possible. Plus, if you leave it in there you will probably damage it, including breaking off little pieces that could flow into and plug up your power steering pump/rack and ruin it. Turning the wheel stop-to-stop without the engine running might actually push some fluid through, but the fluid ain’t flowin’ unless the pump is pumpin’ - the engine needs to be running when you rack the steering. Racking the steering is mainly to get air bubbles out - you definitely need to check your fluid level after that to ensure you have enough fluid in the system. Please, folks - don’t follow this video!

These cars are very picky..just as shown in video, always use hitachi coilpack/ sensors aftermarket parts will cause failure.

Good video. Nice car.

i have this probleme did this week ,. im going to garage but it's nice to see how

Did u fix ur leak?

HOW did u install the window?

This is the second of AGBoyz videos that I have viewed. I Greatly Appreciate the simplicity of Their “How To.” I own a 1987 300zx, and there are a few items that have to be addressed with Ky Car - the Slave Cylinder is by one of them. With little to no experience, repairing Cars, the AGBoys video has Me Inspired to replace both My Slave Cylinder, and Clutch Master Cylinder, and😊 perform😊 the repair from

Thank you bro gotta do this tomorrow lmao

Ooo shit you got the same rims as me

this is literally the only video about this on youtube, thank you for this bro just fixed mine from the same issue.

where did you get it and hows it workin for you?thanks

legends.

Ayyyy that wing looking hecka good👌

Yooo the car looks sick👌🔥🔥

The gap in the old spark plug was correct the new plugs gap need to be adjusted

Is it still holding up??? bout to do this asap been leaking mad long

the new lip makes the 350z look much better! keep uploading more 😊

Hi, first

@13:00 bruh do it 20 more times

How did you get the wiper out as mine super stuck

The led I the interior is a no go

you made his lense dirty 🥺

First

Those 2 bushings that hold one side of the window, what are they called and are they reusable? super lost can't find diagrams or names of the part or anything

Thanks for posting , u saved me time & $215 diagnostic fee from the stealer.

350z looking good

the paint on the new wing looks good bro. 👌

Was it bleed

Not the “Pinche Wuevon” 😭💀

More Nissan 300zx videos ! F the rest

Do you actually turn the car over so it's running when doing this or just Axillary? It is not clear. I did it on Aux, turned the wheels as shown but nothing filled the reservoir......

My Z drinks a bottle each day 💀

Ouuuu it looks pretty! 🤩

that subie is clean.

What intake is this I have the same one on my 03 z haha

my engine was idling really rough but I see my mistake and that was that my ignition connectors were switches thanks to you and first video that shows them how they are plugged in I was able to see that I had them plugged wrong so thanks.

It’s about time lol

Where’d you get the cat back at?

Nice video. Flex seal tape is another good option vs electric tape I used it on my G35 when water was getting inside.

it fixed the misfire? did you have codes? i got p0300 and p0172 (rich condition) changing out sparkplugs, and hopefully that does it. If not getting 6x new coils, and if that doesn't do it 6x new fuel injectors. fml lol

Thank you for these videos! They are very informative and easy to follow. ^^

I like the vlog style

woke up this morning with my clutch biting point all the way to the floor lol will try doing this later today and ill report my results edit: well it helped but unfortunately, there's no more room to adjust and it's still pretty low : /

I love it ma boys, keep it up and rolling ✊️😄

hi

hi

Yo, I'm thinking about getting a z31 and these videos rule for helping get a feel for how maintenance might go. This might be bold to ask, but do you think you could make a playlist for your vids on the z31? I would super appreciate it!

did you bench bleed?