วีดีโอ

Thank you so much you saved me lots of 🕰️ and 💰

Thank you so much for this video. I bought a brand new blower motor and it still didnt blow and air. I then stumble upon this video and saw my connector was burnt as well. Replaced the pins and my ac is working fine again. Once again, thank you!

Your video helped me fix my truck! I relocated the gauge cluster ground and it worked like a charm! Only took a few minutes after 2 days of troubleshooting. Thanks man I really appreciate it! I’ve had intermittent issues with my gauge cluster since I bought the truck but it never did this until now, thanks again

Why front sag and back doesn't is it the same system 2011 equus

Any ideas i push the drain pipeline back and i can't retrieve it any help most welcome thanks

What's the name of the jumper plug

Guys save your time and just pull down the back seats, crawl inside the trunk and pull the trunk emergency release cable. It’s literally 1 min job.

Thank you so much, my friend! Send me your email, I'd love to Zelle you a cup of coffee, at least🙏!

THANK YOU SIR !!!! AC worked perfectly till a few days ago started right up after watching your vid

Thanks a lot bro. i had the same problem

Thank you sir!!

shit my shit been going into low power mode

You save us a lot of money. That was the problem. Thank you very much.

I only got 002ACC is that the same or must the other code also be involved?

Wow thank you

You saved me a lot of heartache , $$$ and shop time. I had EXACTLY the wire plug issue in your video. Easy fix. Bypassed the plug with red wire and made solid solder connection with a lot of insulation for permanent fix. Thank you so much for posting....

Wish you would have shown you poking holes and where you connected the power

It will come back, you can't fix these cars

It's so stupid to have computers in vehicles, when in the 70 and back ran without computers. It's all about the money 💰

I have a 2014 ml350 4matic and this was the problem with the blower cutting off. Thanks so much, a mobile mecanic was charging me almost $700 to put in a new blower motor but its not the blower motor. Thanks again.

Brother,Im having the same code issues for my 2013 equinox my reduced power is coming on and stabilizer track light comes on once im stopped at the light.... Hopefully this week im going to buy this pump and i hope it works 🙏

in my case, this was not the issue, all air lines smoke tested....both rear shocks smoke tested and only about a year old, new compressor new valve....rear still drops intermittently ...makes no sense...fuck these cars!!!

What was the check engine code?

what kind of wire did you use?

Where can I buy the connector pins?

m.o.s.t

or just put it in service mode (3 press on the start button) release the hand brake and put the gearbox in N and push it

I’m experiencing the same issue, if the cas was bad would the car accessories still work? Mine are all working

Question... 2011 Equus Signature air ride button will not lower. It stays in the up position, all the time - 3 or 4 months. Prior to 4 months ago it would lower when you pressed the height button. Now it won't lower. Suggestions, comments and concerns please... Thank's

The cam position is wrong mate, them dots on the sprockets should be in the near centre of the windows. Ive got a 3.0t caka and I've done the upper timing chain tensioners and guides with the engine in the car. Nightmare job but had to be done as timing had jumped 1 tooth on the vvt inlet sprocket. Yours seems to be retarded by 1 tooth on booth sprockets or you just needed to rotate your engine back a tiny bit. Either way at the edge of the window you will get some codes for timing being out. Good luck.

I also have an 04 F150 ,exact symptoms I have, great vid hope it helps me get my truck running thank you

Thanks for the input, much appreciated. My in laws had their Verano blow the engine due to timing chains let go while driving, when I was swapping out the engine id noticed the fuel pump wasnt included with the used engine for some reason, and I didnt trust the one on the blown engine. Bought an aftermarket one from what I was told was a good company, and a few months after they've gotten the car back, these codes have come up. Ive driven it extensively and only seems to act up at a stop light.

what about the rear drains

Excelente. Except for one detail. No brown and red wire. Only brown. Also what works best is placing the wire into the device first and then scraping the wire to the battery. Great

Before you replaced was the car randomly turning off?

I am experiencing the same issue

What was the issue and do did you solve it

I am having the same problem on my 2019 S560 with 53,000 miles. Oil separator failed causing the rear seal to leak. Now dealership is telling me $ 8,450 repair cost and they have to remove the engine and transmission to repair.

Thank you man you are a lifesaver, saved 15 hundred on this.

Tried the standard air gun didn't work

Did you get it fixed

For the crank rotation as long as the water pump is topside its ok?

OHHHH MY GOD This is Exactly what i just paid Mercedes 230 to tell me because this is the only video that exist showing this issue. Thanks for posting this.

Thanks for this vid. Fixed my problem. I knew about the grounds on the pass side kick panel but had no idea on the driver's side thanks again

Yup, BUT ALSO- check that main harness where it lays along the drivers side valve cover. There are 1” tall studs that hold the coil pack tray, they poke straight up and chew through the plastic loom, grounding out any number of sensor wires. My PO641 affected HVAC sensor, alternator signal wire, and finally Accelerator sensor. My throttle went to 3500 with a mind its own. Crazy GM didn’t put some kind of plastic caps on those studs and just laid that massive harness over the top of those. This has to be getting more common problem as these popular models get older.

First, thanks for posting this video. Is there a part number for the connector? The housing on mine was melted more than the one you show.

Great idea and awesome job, I will probably find an installer in my area to install. Thanks for sharing.

Literally you show everything but how to access the wire 😆 can’t fix it that way

I had the rear of my car jacked up to replace the rear wheel hubs, and now the rear air suspension will not raise back up I don't know what the problem could be it was fine before I jacked it up.

is this also an issue for 07 sequoia? im having this same issue sometimes it starts right up other times not at all just a really long crank but no start