วีดีโอ

Thanksss, you solve my problem!

A buddy stole my lighter so now I can’t light my joints

It’s works

Very helpful

Not possible with phillips hair dryer

Hi XoZart!!! The day before yesterday, I started the car and at 2000 rpm it threw out the signal, oil pressure! I stopped immediately and went home to the garage, I drove the car for 50-100m. We measured the oil pressure with a manual instrument, which was 3.5-4 bar even at idle. For this reason, we thought that the sensor would be the problem here as well and replaced it with a factory part. Even after this, the error did not disappear, the oil pressure problem immediately appeared on the dashboard above 2000 rpm. What do you advise me to do? The V-square was completely renovated 2 months ago, the engine is as clean as a hospital ward. The oil pressure sensor connector also appears to be in good condition. Could it be a broken thread or dirt somewhere in the motor? when the v-square (v6 suquare all silent , oil-cooler part etc) was renovated, it received a full Motul oil change with new filters. I drove the car 2-3000 km since then and now the error appeared. I am very anxious about this now because I take good care of my car. 2007 3.0tdi BUG q7 too. If you can help, give me advice. Thanks

Clever way of doing it good job

You could thank the transformation of energy for that one ! 😂

how to program control of audi q7 2007

I have same problem for the q7 4m anyone know how to fix as i see no sensors near latch

thx man after wasting 4 hours unscrewring the wrong screw i found your vid and really helped me a lot to fix da damn door xD

keeper! A life saver fr needed a cigarette, no lighter u saved me!

what M is this XZN ? thank you

Thanks

These fucking AI voices are beyond annoying

Now my original key doesn't work

Do you still have backlight illumination?

👍

Thank you so much man sittin in a hotel with no lighter 😊

Are there parts for this bike available and complete panels

It’s the same work to do also for a Peugeot 207 cc from 2009?

My q7 high beams are working but low beams not ( I’ve changed fuses and bulbs ) do you have any idea why those are not working?

WRONG! Only 505.01 oli for PD injection sistem. 505.01 Have special oil aditiv !!!!!

How do you replace the breather hose from behind

Doesn’t work

love this video

thx, now its broken

thanks life saver man

did this, now the door wont shut and a door hing bolt has sheered off.

Are you f serious??? 7:09 You need to remove the outer door panel mad man!

Wow thank you very much!

Thanks mate! All in one place, short and no BS.

I will give that a try thankyou. 👍

That’s what she said 😂

You Sir may just have solved my problem with your video, I've had a parasitic drain for weeks, couldn't get to the bottom of it, only had the Q7 a few months, had the battery changed, worked for a few days and then dead battery again, but when I was trying to jump it earlier from a donor battery I noticed the open tailgate light on the dash, I went out, opened it, couldn't see any obstructions closed it again, went back inside and it was showing it closed, then I remembered that it did it once before a few weeks back, so I looked on here and came across you video....I'll check tomorrow, I really hope I have the same fault, thanks

Will try when I get my car back from a recall job :)

Is this only for vertical adjustment? Because my door vertically correct, but i need horizontal as the gap between my driver door and rear passenger is 1mm larger than left side doors.... In summer the door rubs against the fender making a irritating noise.... I want to adjust horizontal to close the gap a bit between the 2 doors

Which OBD are you using?

Hey man what exact year/model car is yours? It looks identical but wondering if mine is the same.

What year is your Audi

That way you only adjust door in and out only. To adjust it up/down you need to remove panels insider and loosen nuts , lift door and tighten nuts.

My audi Q5 boot will not close when press the button,we have to force it down! Any suggestions please guys,

Really nice camera angles!

Not everyone has a welder

at first u need to wash a bike !!

what this chune damn its deep gimme the ID

This video never get old. I just recently got a car and has this same issue. I don't know how to fix it until I saw the video made it so clear and very intuitive to use a nice piece of wood to evenly get the door up. I didn't even know that the boots at the hinge could be adjusted vertically, because from appearance the hinges don't appear to have any vertical adjustment, but this video shows it can be done. So I going to now have a confidence to fix this damn door. Mine is worse, at almost a half inch low. I have to slam the damn door, and the wind leaks in because the door is off in my scenario. So this is great video no matter how old it is. Thanks!!!

Thank you so much neither one of my keys were working and I did this with one on the ignition then vise versa and It fixed one of them !!!!

You did it backwards. According to the service manual you are supposed to drain the tank plug first then the bottom engine plug. You're also supposed to clean the secondary tank filter with compressed air. What is up with the capacity? It should take 2.2 l including the filter change, but you say to add 1.6 first, then add another liter?

Works fine for audi a4 b6. Thank you!