วีดีโอ

Have a HR44A Tillotson Carb. Starts but wants to go way too fast like a jet out of hell.. Adj (fast and slow) screws don't slow it down. The throttle 'doors' are closed... do have an air leak somewhere ????

My engine in half throttle keeps like taking fuel and then Len it, it’s not stay contestant!?

dear sir,my engine work idle until choke shutter is completely close and when I start to opening the choke shutter,engine accelerate with very high rpm for few second and falls,I don't know what is the problem!

what screw do i need to turn to make it lean or rich? mine is running really rich , spark plug last for 30 mins only, when we takem off the are like peach black

Tillotson carbs are not meant to idle in the sense that if it is idling it will bog and possibly flood in the low end around turns. This is true with racing karts as this is what we tend to run. It is a simplistic design, but tuning the high/low speed jets can be tricky and takes running the kart (on the track) to get right. And no single setting will work best for each different carb. We have found that what may work for one carb most likely will only be a baseline for another. While I am still new to kart racing, it is a great carb to run for this application.

What kind of mods if any or adjustments do i need to do to the tillotson to run E85 on a stock HL-334WX?

get rid of the needle bearings and replace with roller bearings

Hi man, i have a Tilloton HL-166B in my kart with Comer 80 engine. When the fuel is sprayed directly into the cylinder engine starts. But when I try to boot normally through the carburetor and the engine draws in gasoline. I headed it cleaned but still it does not work. Could you advise me what is the problem? Possibly replace what? thx

Great video, very easy to understand. Thx

IS THIS LEGIT? ANYBODY TRIED?

How do you compare this carb to a mikuni flat slide or square slide carb? Better? worse? equal?

Hi, I have a single rotor Wankel powered glider with a Tillotson carb. Above 7000' and around 3/4 throttle I have coughing and hesitation like the mixture is too rich. The engine runs much better at 1/2 throttle and somewhat better at full throttle. From your video it looks like the first adjustment you make, setting the blade, is the only control I have for mixture control. I will try opening the blade a bit and see if things get better. Thank you for your video, 2 thumbs up even though I am not a kart driver.

Looks great....... But is it as quick as Eddies fingers ??? Lol

Is it available in 1inch bore for a gx270

Fantastic Design and Forethought into this.

hey i got a tillotson 320 on a snorunner. my sled came w no muffler so i bought and installed one. it ran fine without it but now wont even start. i assume its a carb issue so i tried adjusting but dont know what im doing. it only has two adjustments a H and L where do i start turn both right and back out or vice versa. any help would be appreciated

Good vid. That does look pretty cool from the sidelines. Was a hoot to actually be in the kart doing it as it was my first time in so-called gentleman's street race.