วีดีโอ

Merci beaucoup 🥰

Je vous tag on insta!

Ahhh thank you 💞

It’s not mandatory but as we swear by a fast and easy removal, we suggest you use the Heating Mittens as it’ll also help to preserve the integrity of your natural nails ☻

We love a good asmr over here 🎧

We haven’t launched our GELCARE cleanser yet but meanwhile, you can use the GELCARE Touch Up Pads with alcohol ☻

Maria ☻

Thank you so much 🥰

Pinot Noir

Hi, after flash curing after each nails, don’t reapply base coat, just go ahead and cure the whole hand for 60 seconds ☻

Yes! The Gelcare Cleanser isn’t available yet so we recommend using the Gelcare Touch Up Pads with alcohol meanwhile as an alternative. It’s important to wipe the nails after curing the top coat to remove uncured particles of gels that could slide down with cuticle oil near your skin and could result in unwanted skin reactions. It’s also important to wipe before applying base coat to make sure no oil is left on the nail bed causing the base coat to lift. Read our additional resources on our website in order to learn more on safe ways to use gel at home ☻

@@GELCARE thank you so much, I love your gels! I love that you put quality first and use safe ingredients in your gels than traditional ones! I just used the rose water one, it's gorgeous <3

Thank you so much 🥰

Tysm 🥰

Thank you 🥺

If done properly, and with practice, your manicure should last 2-3 weeks. We don’t recommend keeping it longer. For a beginner, it could take several hours but eventually, 2 hours for removal, nail preparation and gel application should be enough. You can surely use the same process for toes and also use the Gelcare Pedicure Kit ☻

We can surely assist you and help you out! Send us a DM via Instagram - @gelcare.official ☻

Ça fait plaisir 🥰

Thank you! 😊

Hi Lynds, you can apply it after your nail preparation steps so right after you wash your hands. Then wipe/cleanse your nail beds with the touch up pads and alcohol or nail cleanser if you have one ☻

We love to read about it 🥰

Our Gelcare Nail Cleanser! We’re currently working on it so it’s not available yet. You can use our Touch Up Pads as they’re lint-free and alcohol for now ☻

If your concern is that your gel is still sticky after applying your base coat and your color, rest assured that this is completely normal as it allows for better adhesion. In fact, it is only after applying your top coat that your manicure will have be completely dried and sealed ☻

Ça fait plaisir 🥰

Ça fait plaisir 🥰

Thank you so much! Yes patience and practice is truly the key ☻

Thank you so so much, we really appreciate 🥺🫶

😂

Thank you so so much 💘

Hi Marie-Anik, We are sincerely sorry for the inconveniences and problems that the use of our GELCARE products may have caused you. The health and well-being of our customers are our priority and we want to inform you about the best practices for using gels at home. This is why we have always put forward warnings as to the proper use of our products through detailed instructions. In order to be even more conscientious towards our customers, we have created a platform on our website to provide you with additional information regarding the use of the gel at home. This page is available and accessible on our website as additional resources. We have listed several essential tips and warnings in addition to the educational tools that we have always shared to ensure safe use of the gel, in accordance with the best practices identified by the industry. We therefore direct you to read this page and we hope that it will answer your questions. We care about all our customers and rest assured that we will continue to listen to you regarding the use of our products.

With the new GELCARE development, the recommended curing time is 60 seconds to make sure each layer are fully cured. When this video was made, we were following different curing timing ☻

SInce we’re working one finger at the time for the base coat application, we like to flash cure. So basically, apply base coat, cure 5 seconds and then proceed on all fingers. When done, cure the whole hand for a minute ☻

GELCARE Top Coat is non wipe. Even though the surface won’t be sticky, we still recommend wiping the cured top coat with our touch up pads and rubbing alcohol since particles of un cured gel on the surface of the top coat may cause a skin reaction if not wiped off.

Thank you so much 🥰

Thank you so much for sharing this comment with us! We really appreciate 🥺🫶

The nail tech should only be taking off the bulk of the product down to the base layer and not your actual nail . If tech is using Efile correctly .

Yes of course! ☻

@@GELCARE sweet!! Thanks!

Thank you so much ☻

It would depend on the specific nail art you’re doing. If you only want to add rhinestones, you can only apply the top coat around it. For glitters, you’d need to apply the glitters and then apply top coat to completely seal the manicure ☻

Happy to read about it! Thanks to you ☻

Thank you so much ☻

They key to healthy nails is in the takeoff technique. A bad removal can lead in fragile, thin and breaking nails. We’ll always do what it takes so our customers use the right technique to get healthy and strong long nails. It isn’t for everyone, taking care of your own nails is time consuming but we’re all about it ☻

Oh thank you so much! We absolutely love reading comment like yours ☻

agreed!

Your nails are flawless ❤

Noted, will pas this request to the team! ☻

It’s currently in development but you can use rubbing alcohol ☻

Oh no! Hope your nails get well soon ❤️‍🩹

We’re glad this could help achieve gel manis at home ☻

Thank you so much ☻

Thank you so much 🫶

Thank you so much for your comment, we truly appreciate 🥺🫶

Hi, Base Coat is only applied once after the whole nail preparation routine. Please send us a dm via @gelcare.official on Instagram so we can help you further ☻

The technique used in the tutorial is the same as the picture in the thumbnail. Colors can vary depending on the layers applied. If you’d like a finish that’s more pink, apply more layers ☻