วีดีโอ

😂

CBR600RR

Sorry. Bike is sold. But I do have a Yamaha 250cc Motard.

Only when stopping or in the woods.

@@Nikel87 what? When stopping?

With the smallest rear sprocket i could fit it overreved at 150km/h. It needed a 6th gear.

@@Nikel87 the WR and XC both have 6 speeds that should drop right in

It is what it is =)

Med helt knasig bestyckning så går det rätt okej nu. Men något är fel med den. Projektet ligger lite på is XD

Enduro reggad. Det finns endel LV reggade 430 maskiner som säljs lite här o var. Supermotard modellen finns inte utan det får byggas själv.

Sprockets are cheap =)

It's actually very lean compared to track jetting. It runs so much cooler on the street so the jetting is adjusted to it. Could go down 1 size on main but it isn't important to get 1 hp more

Lol you're a dumbass

Soyboy?

150s in the rear. 160 give some issues with chain clearance.

@@Nikel87 thanks man. Really appreciate it. I'll post a video when I get around to finishing it.

Nikel87 how many hp does it have in the papers ?

Shifting? It's a dyno run. We run it until it stops revving in one specific gear. 8000 rpm.

supertedogpriken Funkar lika bra ännu.

The CR500 is sold to a happy fella. I bought a GasGas 300 instead. Wanted something that was in between the maniac 500 and something you actually could drive regularly.

If you say 73 hp on an 430 I must doubt it very much.

Nikel87 say what you must..

Brian Baker CR430 will not make 73 whp without serious modification.

My '87 Husky WR 430 6-speed 2-stroke was bored & stroked to a 500cc, ported & polished valves, jetted, carbon fiber reeds, & a torque spacer plate added between the carb & reed cage for good measure! Was putting down about 68hp @ the wheel, torque was nearly the same. Kept the stock expansion chamber (since the setup was already made for low-to mid/hi range rpm power) & only added an Answer silencer. Since it was my 2nd bike & I was 14 when I put it all together, it took me YEARS to get used to/control that monster bike! I also had to physically grow more to handle it too. I was upgrading from my 1st bike, a learner/beginner.. A WEEK '82 RM 80 I'd HAD SINCE i WAS 11

My '87 Husky WR 430 6-speed 2-stroke was bored & stroked to a 500cc, ported & polished valves, jetted, carbon fiber reeds, & a torque spacer plate added between the carb & reed cage for good measure! Was putting down about 68hp @ the wheel, torque was nearly the same. Kept the stock expansion chamber (since the setup was already made for low-to mid/hi range rpm power) & only added an Answer silencer. Since it was my 2nd bike & I was 14 when I put it all together, it took me YEARS to get used to/control that monster bike! I also had to physically grow more to handle it too. I was upgrading from my 1st bike, a learner/beginner.. A WEEK '82 RM 80 I'd HAD SINCE i WAS 11

neko266 I would guess around 1.8 meter.

same same Had the wrong oil in it.

Ah, i have a 500 and 250 honda, i fill the engine with motor oil of car, is cheap and good, i change often.

same same in my new GasGas 300 I actually run standard 5w30 engine oil. Works great. In the Husky I used ATF. And that made the clutch work fine.

Kelly Turner I bought a new carb from Ali express. And that needle worked 😂

so you brought a whole new carb ? is there not anyway you can just buy the needle ? thanks for getting back

Yeah. Sure, you can buy lots of needles. jetsrus.com/a_jets_by_carburetor_type/needle_keihin_N427-48.html

Gage Hamel I'm guessing you're quite young. Husqvarna have had CR models for over 20 Years. TE wasn't invented in 1987. So yes. This is a Husqvarna 500CR.

Bozo, CR is Husqvarna for Close Ratio, used it WAAAAAYYY before honda stole it. the enduro bikes were WR for Wide ratio and there was an XC for cross country..gears from both CR and WR...you have been informed...

Bozo, CR is Husqvarna for Close Ratio, used it WAAAAAYYY before honda stole it. the enduro bikes were WR for Wide ratio and there was an XC for cross country..gears from both CR and WR...you have been informed...

Gage Hamel 2 stroke huskys back then we're designated as CR's . Look it up dumass!

dumbass*

I have sold the bike. I can ask the new owner if you like?

Nikel87 That's ok, thankyou for replying :)

husqvarna 500 1985 Maybe hard terrain. Maybe bad riders ;)

cecilyt006 It's magic music.

Alpha Chinoz Allot =).

Oh my f*cking God... Dude, you replied 12 minutes after I posted the first comment in a seven year old video... That is very well done! And I see, I tried to remove paint with just a little, and it didn't work... :P

Alpha Chinoz Well of course. my phone rings when people comment so I try to reply as fast as possible =). I'm not sure that it's the same ingredients in it anymore. But yeah, thick layers worked for me.

Totty Yupp. Twostroke

Sure you can use This video.

The compilation with your video is up on our channel now if you wanna check it out. It's the Funny & Hectic Dirtbike Crashes. Thanks again for letting me use your video.

Kaos Riders Awsome =). Hope it will come to good use. My friend's crash is worth to share XD

Drone Girl We're just a bunch guys having fun =). Hello Ireland.

Drone Girl I like your drone videos. looks amazing. I think I need one.

I can't remember really. It's a free song from FeeSFX.co.uk

thank´s anyway...