วีดีโอ

Doesn't lrst cones woth usb connection fron factory located at the frame by the front wheel?

Can we talk about what causes these codes and not just what they are and how to clear them so we know how to avid them???

Thanks

How much of an improvement is this over stock?

Thank you very much. In the entire TH-cam universe, you are the only one to make videos explaining step by step the tracer modes✌️😃

Thank you

Can I ask what bracket you used for your lp6 install?

Thank you so much for the video! Do you know if I have paid for OnStar subscription service to get Super Cruise to work?

👍👍👍👍👍👍👍👍 Nice and clear !! Very well shown and explained !

Straight to the point, love it!

How the lap time is activated on the track, I put it on and didn't run 😞

Thank you so much for the video brother such a big help 🙏

Does that bike have a cam upgrade or just the pipes? Sounds surprising good for a new Harley. Did they retune it after the pipe install?

Want to get bags like that for my Low Rider as well, the look great! Was wondering if you knew, they obviously work with the S&S exhuast, I was looking the Vance & Hines PCX Pro pipe which I think may sit just a little higher than the S&S pipe. How much room do you need with the saddlebag bracket? Would most 2 into 1 systems work with it?

apps.apple.com/us/app/batterylab/id6462673217

I noticed you already changed from the eagle light headlight to this. What happened? Just cause you could upgrade? Was there anything about the eagle lights headlight that did not work for you?

Right after testing my car battery, I tested my motorcycle battery. It tested poor. That had a greater than 2V drop. The motorcycle had a couple suspicious starts in spite of trickle charging it which is why I bought this checker. I would have shown that in this video, but Honda buried the battery in the bike, and I had to use a screwdriver on the positive terminal WHICH IS VERY RISKY! Touching that screwdriver to grounded metal would have been some fireworks. I couldn’t hold everything simultaneously, so filmed the car instead.

The app is BatteryLab

Can you adjust the seat on a lower position that the original?

sweet ride. Enjoy!

I think a better way to go would be to take the gas tank off completely and run the wires through the way the factory wires are run

I forgot to mention the Advanblack short levers that you can see in the video. The clutch pull is easier and better feel. They look and work great.

Those grommets for the windscreen aren’t that bad if you’re careful. After I got them in you can’t tell that any bits and little pieces came off 🤣 I believe this job can be done better if the gas tank is completely removed. That way you can run the wires for the LP6 to the battery neater and probably easier. Everything is probably easier with the tank off. Comment please of you have experience.

Go through the rubber grommet area to go through the frame down to the battery . Long zip ties help to get it done there .

Same thing happen to me In the advan video he makes it seem like the bolt is long enough to hold the tank It barely has enough to hold ..

Thanks Tom. I used your video as well as the advanblack install video. I installed my mounts from the engine guard backwards initially too. For the cables in the boot - if you take the boot out more it'll be easier to connect cables - Just lift the tank up a little more to do that. For the turn signals on a 2018 FLSB I was able to pull the cable through without de-pinning - I tied a small string to the connector in case it got stuck - it didn't get stuck.

Great video, thanks

I believe the relays that come with the LP6 light should be mounted inside the inner and outer fairing. Look to see if that can be done.

I see comments on social media about having to reroute the clutch cable. I have stock bars and left as found with the clutch cable routed through the triple tree. I have no issues with anything rubbing or restricting lock to lock.

great video

Here is the video I used to help me depin the connector. th-cam.com/video/aDBzQ4DqPz0/w-d-xo.htmlsi=6abhaJyN-lpnQc4r

Got the Yamaha dealer to make 2 plates that raised the height by 8mm in the front section, thus cancelling out the "sporty slope". Then, raised rhe handlebar with aftermarket raisers so the posture is more straight. Together, they worked pure magic. No more backaches, hand tingling & acrobatics

You did a nice job with this video. Very helpful!

Nice video. Thanks.

Hey man! Where’d you get that awesome brake pedal??

Nice to know. I got the 2023 loe rider s yesterday it wass my #1 time

Update on LA Harley Davidson - They did not follow through with replacing the exhaust heat shield. Parts department says they know nothing about it. Service department just gives me excuses. I’ve been dealing with Huntington Beach Harley since, and so far they are great.

Hey there You said that you had Advanblack install the bags so where are they located ? In Ponona?

Could you fit a passenger peg with the advanblack saddlebag conversion brackets?

Where did you get those bag lights???

I'm missing something, can't feel the lever. Would have been more helpful had you shown us the lever once the seat was removed. Thanks though, you've given me an idea of what to search for :)

See video description also

Other than the two headlight codes, that third one was the battery.

harbortownhd.com/trouble-codes

To expose the positive battery terminal that plastic piece that I unclipped only has to be pulled out about 1” or so. Then you can unscrew the positive terminal screw and attach the Garmin positive ring terminal.

Thanks!!!

It looks like the EUV is not very different from my 2019 Premier. Other than a couple of cool new features (and better seats), the EUV is basically a Bolt on steroids.

After adjusting the headlight it looks better in the fairing. I don’t have the same gap at the bottom of the headlight.

You’ll need sets of SAE Allen wrenches, torques head wrenches, and two 9/16” end wrenches. Cover things like fenders with cloth just in case.

Sorry about noise. The lights are running, brake, signal, and emergency flasher lights.