วีดีโอ

Thank you.

Sweet!!! A Grumman boat, and 1 of the best OMC motors around

Cheap dollar store toilet bowl cleaner, a brush, a little elbow grease, and a pressure washer/car wash (if you don't have pressure washer) will do the job. I'd be afraid to use any steel wool on my hull- it would strip off the paint.

I have the same one, runs fine for about 2 starts then won’t start for an hour or 2 . Guessing it is getting flooded ? Any suggestions?

👍

Can you make more videos about simple repairs on the motor because I’m trying to fix up the one I own please and thank you

shes got a good water pump

Napa Auto, has a cleaner (Aluminum Brightener), for about 7 bucks, works very well. Forget the small spray bottle, get a garden sprayer, better fine spray, and easy on the hand muscle, i used it on my 2020 Bennington 20 ftr.. be sure to read the dir.. You still need to wax to protect, a car wash wax works fine.

Thanks man i had a hard time cleaning a aluminium boat that has been sunken for over 2 years

I have a same outboard as this needing a whole new lower unit do you know where I can get one?

I just received one of these motors for free and I am looking for some help. Does your model number happen to be J25RLEND? Also, does this happen to be a 2- Stroke motor?

Is smoke normal ? I have same engine I wasn’t sure if it was 2 or 4 stroke

What did you seal it over with?

do you need to do the entire bottom?

How does the Run Lanyard connect to the remote?

You wouldn't happen to still have this motor? I have the same one, took off solenoid and forgot to take a picture of the wires and now am trying too figure that out.....lol

Good engine...little too much oil in your gas...or else it would run smoother and quieter with more throttle jump

very helpfull going to try, thanks

What kind of gear oil/ lower unit oil should be used

Kind of noisy ain't it?

Thanks for the video

your boat is painted man

Do you still have the motor

Can you tell me the fuel mixture ratio? Thanks

just bought the same motor. sounds just like this and I thought out was missing. good to know it's running right lol.

very helpful! I have white painted Lowe, will try this 4sho in the spring. thanks.

That looks like it works really well. I have have also used toilet bowl cleaner and a scotch bright pad to remove pretty much anything off the side of the boat too.

Can u show how to take the carburator off and clean it

Thanks alot. I do find this video very helpful

what grade steel wool

I have an 87 mariner made in Belgium. I cant figure how to get the kill switch out. Can you help at all. cheers wayne

does the mag wheel cleaner effect the finish of the boat like dulling it any

Thank you. Very informative. What about ACETONE ON ALUMINUM?

I made the biggest mistake leaving my pontoon boat in the Indian River in Florida. I end up with clam shell stuck to the Aluminum hall. I work on it for two days. Still they were still there. After that I used a protein torch and got it clean in a shorter time. Try it.

How much?

The surging went away when I placed a load on the generator. Unsure if this is common but I will look further into it.

Thanks for sharing.

thanks

Is this normal behaviour? Propably going to buy one of these and wondering, what to look out for

I like the sound of these motors

They can be very good motors. As long as they were maintained and its running well now with the right compression you should be fine, of course that depends on what you are paying.

What are they like are they reliable have you had any problems with it, i am going to look at one tomorrow.

Great, report back with the results!

Thanks for posting. I'm going to try it on my ' 95 Tracker.

Sounds good! I love mine alot.