วีดีโอ

How do the washers help? I think this will fix my problem just not sure how that works…

That’s exactly what I did to try and get the stud out but it didn’t work it ended up stripping the threads. My XJ has a small lift and it has a small vibration only when I accelerate. It has all new fluids and ujoints so I was seeing if a tc drop might get rid of it.

Why are you adding a drop to the tcase?

Subscribed. Thanks for helping me get my steering wheel straight again Rob! -Frank, Prescott, AZ

Just did all 4. Thanks my dauther will like openning the door on her own now 😂

Them shoes getting low 😄 or them drums getting thinner.

Wish I knew this in the past. Owner numerous 97+ xjs and my current one is the worst regarding the door buttons. I took apart the latch and built up tack welds where the button depressed slowing it to fully open. Can't believe I looked over any factory adjustment 🤣

Where is your driveshaft? I have a 92 XJ and I can only get about 1/2” of swing because the drive shaft is about 3” directly below the handbrake cable.

Thanks dude!

#Salute I hope this is the fix for my front passenger outside door handle on my 98 ZJ.

I was fixn order a new door handle for 12 bucks on ebay..Grabbed my wd40 and my 5/32 allen..Less then a minute..You are a sweet fellow..Change title to jeep handle replacement and adjustment..I lucked up and found this..Thanks

U have no idea how long i have bean looking for that video 😂 thanks bro

Amen... Thanks Boss.

Thank you so much, Exactly what I needed to know! Cheers my man!

Hey Rob! Wondering if we could design and cut some decals for my hood vents? 🤔

Just came across this video. Well done bro. Cades Cove JO such a cool store! OIIIIIIIO

Muchas gracias, no encontraba información al respecto hasta que vi tu vídeo.

Wow. Thanks so much.

That was easy!

Nicely done, so when I go to Lowe's what do I ask for?. If I ask for a flange they're going to take me to the toilet section.

Is this compatible with the automatic retractable roof?

I used the Long 1/2. Bolts and 3/4 nuts for spacers. The nuts were a lot stronger than just using pipe

should have used 2X1 thick wall tube and 3X1 1/4 wall angle. the tube length wise for the one in drop, the angle welded to the tube for side bolting onto the frame. all this way to prevent side ways tippling and a very strong support for sliding over the rocks. those pipes and all that open area is going to bend and break those bolts. plus thin wall... really.

Thanks for sharing

I noticed my driver rear door was being much more stubborn than the rest to open, this fixed it and now opens like the rest of my doors. Thank you so much! The Allen bolts looked like they’ve never been touched since the Jeep was built 23 years ago, so if you own an XJ fix this before it fixes you!!

Finally got to see how that works. Cool!!

How has it held up? Looking to do this to my 94

✌✌

Cool to see your brand developing.

Nice!

Yo! Hope y’all had a wonderful Christmas!

Keep posting

Sup bro 👊🏻👊🏻💯

Any updates? One bolt is enough?

Thank you!! I also was about to rip my doors apart. 👍👍

Is it still holding up?

Stop shedding all over the place then Rob. Lol

That sux! I had a similar incident with my old Bronco. Basically got it looking brand new and someone pulled out in front of me. Thankfully the damage was limited and got repaired but I was pissed.

Thanks for sharing! How would I find the creek area you were exploring at the end? Headed to ToT in the Jeep this weekend for some camping.

Cool timing to catch this one. I just got back from a decent test drive myself. I just got a 2006 F150 that has sat parked for roughly 4 years. It only has 15,300 miles. Changed the fuel filter gassed her up and took off. There’s a little more to do because it has a very slight rough idle and is sluggish when you put it to the floor but great otherwise.

Damn I'm a dick. Lol 😆

Nice lil Ride you got there an you totally made it!!

Nice work brother! I got a Navy flag I’ll let you fly! 😆

Great idea. Almost looks stock

I was ready to tare my doors apart, thank you so much 🤙🏻

Thank you for sharing.

Great tip! Doing this on mine tonight.

Interesting. Just went out to my XJ to take a look lol. I'll adjust my rear doors tomorrow at work! thanks man. Also, Semper Fi my man. (saw the flag in the garage)

Hope all a well! I’ve crossed the Mississippi but never ventured around it. That creek was a really cool area.

I remember going down to Trail of Tears as a kid to the swimming spot.