วีดีโอ

Really helpful the sessions

Scenario is great just like production but explanation is not proper

Have we formed HSRP on the LAN interface of the router.?

Can you create a failover video for the same

Very Good Explanation..

Bhai, thoda to tez bol leta...👎🏿

Some youtubers speak so slowly like they are not confident what they are delivering. This is one of them...very low voice in all his videos.

Audio is very low.

got some question sir. What if the gateway is pingable but no internet? will failover works? like link health monitor/ecmp?

Sandeep sir, I had watched so many videos related to BGP , but no one has ever explained the real production environment scenario, what you had explain. Thank you for that.

Nice

sound very poor

great video and thx

could add one more comment : " bgp bestpath as-path multipath-relax" & check

your voice is too low,

U messed up bro...not able to understand it😢

Thanks for your time on sharing this information.

What is wrong with the source IPs ?

Thanks Bro....semma useful.

Why IBGP through a switch and not do a direct link from R1 to R2??

Local Preference ISP1 routes @21:49 & 33:12 , Pre-pend ISP1 to select R1 for subnet 11 @29:10, Pre-pend ISP2 for R2 @33:39, Local Preference for ISP2 @39:22

you have not advertised route 155.x.x.x from both ISP1 and ISP2

Sandeep bhai too boring sessions

ASA200 should send default route to ASA 100 ....how did you achieve it..i cannot see any access list or route map..to influence traffic

I think there is some configuration issue here both R1 and R2 default route next hop should be ISP A then the traffic other from AS 200 and AS 300 will go out from ISP 1

Epic fail

Hey You explained beautifully in all videos. why you stopped uploading more videos chapter wise.Thanks for your efforts.....

ebgp multi-hop 2 command needs to be there between ebgp peers

sir what will be configuration if I have both isp links on R1 and want to reach at R5 (aspect R5 is a cloud router ) with equal load balancing

Good explanation.. Thanks buddy

Nice explanation, thanks

thanks for highlighting the bug issue

Thanks

thanks for sharing relevant scenario close to production setup. Make video on production multicast scenario which is being used in iptv service or in DNS service providers.

Hi Sandeep. Nice video and explanation. So for the LAN side of your organisation, would you use HSRP on R1 and R2 so that the core switch/firewall can see one gateway IP?

Nice explanation Please upload for more attribute..

You should have used a louder system so that everyone can hear you.... i have to use music system with amplifier to hear your voice.

If it is not successful, you should not upload this video. It can cause negative impact

Thanks for the video, awesome work. Just one question, i deigned my diagram just like your, however when you shut down interface fa0/0 on router3 and router4, the next hop changes to the fail-over, however, when i ping from R2 to 200.0.0.1 it fails. is there a reason?

How can we configure same setup on Juniper MX routers?

I want to implement dual isp load sharing but my knowledge limited. (I never have known BGP before)

can I configure load sharing without BGP sir?

thanks for these informative videos.....keep posting sir...

help full video nyc thank you

very good