- 4
- 16 709
Joel Hemminger
เข้าร่วมเมื่อ 18 ม.ค. 2012
Supra Transom Remote Installation
This is an installation of a factory transom remote for a 2017 Supra SR 400 Wake/Surf boat.
มุมมอง: 22
วีดีโอ
Boat Trailer Safety Brake Cable Replacement
มุมมอง 14Kปีที่แล้ว
How to replace the safety break cable on a Supra SR (or similar wakeboard/wakesurf/ski boat). This was replaced with an A60 kit purchased at bakes marine which can be found here: www.bakesonline.com/trailer-emergency-break-away-cable-ufp.html Although the kit was for an A60 head, I actually have an XR84 head, so the cable is a few inches longer than it should ideally be. My trailer is from Boat...
Check Running Foot Strike
มุมมอง 11ปีที่แล้ว
Some slow motion video to analyze my foot strike while running.
2017 Supra SR 400 winterization with Indmar Raptor 6.2L engine
มุมมอง 2.8K2 ปีที่แล้ว
Decided to document the steps I take to winterize my engine in case it's helpful to anyone else. I have a diagram from the dealer showing the drain points if that is helpful as well drive.google.com/file/d/1jxakdpcP_3cgzWgUTTLV8nmo0JRZ77nh/view?usp=sharing
We all know why we are here today. My cable did not break but the hook on the end did and now I took apart the hitch and trying to figure out where everything goes. Thank you!
Did you have to drain the brake fluid to pull the head?
I don't think so, but does need to be flushed to ensure no air in the line.
Did the same thing yesterday 😩. Can I reset that mechanism and run without the cable. Not trying to dive into it just yet.
Yes if you release the brake with the lever then you can trailer without it.
Ok appreciate it!!
Good to see I'm not the only one to do that! Great video, You say you're not a mechanic but you sure could fool me. Thank you1
Hey I did the same thing as you and busted the tip of the brake hose. Do you have link for the replacement. I don’t see it.
I bought it at my local dealer, here is a link www.bakesonline.com/trailer-emergency-break-away-cable-ufp.html That kit is for an A60, which is what I used on mine but the correct cable would have been a few inches shorter (for an X84 head)
Your trailer says it is an xr84 and not an A60. Is the kit the same?
It looks like the cable should be a little shorter for the X84. That said I don't know specifically. My local dealer only had the A60 so that's what I bought. www.bakesonline.com/trailer-emergency-break-away-cable-ufp.html
is yours an x84? Mine looks just like yours and I pulled and broke my safety cable. I was surprised that mine is on a 2018 boatmate and it didn't set the brakes.
Yes it's an XR84, if you stop the video at 30 seconds in you can see it's stamped in metal about 4 inches back from the front, yours could have the same.
Hey there what’s the weight of this motor?
Sorry I'm not sure.
Bro - I just pulled mine today while putting the boat back (‘21 MC NXT22). I couldn’t believe I made such a noob mistake. Oh well, I know it could’ve been much worse! 💰 💰 💰 😬 Thanks for sharing.
You're welcome, hope it made the repair a bit easier!