วีดีโอ

It's 💯 % manufacturer's specs. These splices come as a kit....boots, stress cones if needed! Etc....the directions literally specify how much outer jacket, Semi-con, and Inner Jacket, etc...to remove. You follow those steps to the T and God forbid a problem arises you have covered your ass. If u do not follow those directions to the T and use some well intended but disastrous logic and techniques then your ass is NOT covered. Your ASS IS GRASS. As my first Journeyman was fond to say!

No. It's just an imaginary tag number.

Hydraulic oil

Normally Silicone oil....or as per required Viscosity you can select liquid

Too busy these days due to peak time in my project.

Welcome Selva

Welcome dear

It depends. If psv is used for a leak test. It should be calibrated in every 3 days. And if it is installed in normal operation, then the frequency depends on Client. Some places its 6 months and some places its every 3 months.

Thanks man ,👍

Saudi Arabia

Thats a part of Client approved protocol. So, no safety concern.

Yes they were following the Company's Approved procedures.

1:12 should be followed

@@instrumentationabc6846 Can you explain on what basis it is measured. How take the ratio 1:12. Please.

Example: If lenght of the tube is 6 meters then the difference between the two heights from the ground level should be 500mm. I hope you understood.

1: 12 inch should be followed... refer aramco standard Saes j 003

@@abuyahyaumar6809 Thanks, even though already I got the answer.

Yes you're right Shawn

i will surely think about it

I had tested my parker RH4A pressure relief valve. It was set at 8.4bar, and my supply is 10bar. It was pop at 8.6 bar, but the pressure shown on the gauge that i installed after the PRV still goes up to 9.3bar... Its not stable at 90% of the set pressure. Is it normal?

try removing the foreign particles inside and try replacing the trip spring

thanks man

It is a point at which the psv trips at particular set point.

Any tik sound will be come there

Yes

Welcome

What ?

Medium voltage

Thanks 👍

Sorry I didn't understand your question

@@instrumentationabc6846 I mean the types of the transmitters. Iam.from lraq you are from any country?

DP transmitter has several types/uses other than differential pressure measurements. - Used as a Pressure Transmitter - Used as a Flow Transmitter - Used as a Level Transmitter

@@instrumentationabc6846 Thank you to another question because my teacher at the oil training institute was asked and he earns the degree to which the question is answered: Is it permissible to connect more than one meter to measure the current in the transmitter?

Not permitted. But a transmitter can have multiple sensors.