วีดีโอ

The last video of the compressor 2 years late. Excuse the droney tone in my voice, i was tired.

A quick video on Dapols latest coaches. After an initial mistake by myself, they work very well look the part!

Accurascale Manor 7801 Anthony Manor DCC Sound Unboxing and Brief Review

This next installment focusses on the pressure switch.

Rebuilding the massive motor that came with the compressor. I don't believe it's the original but it's a nice one all the same. The shaft is bent so I need to machine it straight and sleeve it.

In this new series of videos, I'm going to try to restore this massive vintage air compressor. Air compressors can be dangerous so I show you how you can test the cylinder to make sure its safe using water which cannot be compressed like air, and thus, no potential energy to wreak havoc.

This is how I fixed the ABS ESP error on my Peugeot 308. This should work for all modern french cars in theory. A little different to my usual videos but it incorporates some lathe work.

This video is to celebrate 300 subscribers! I did not think i would have this many. The press shown, is from my grandad (again). It was in a flood, and became very rusty. But it was superficial. I enjoyed the restoration as it required a number of techniques, from electrolysis, milling, lathe work and using my rotary table. I still need to sort the sound out with these videos, and i also used d...

In this video, i show you how i rebuilt my Colchester Chipmaster lathe. Its a 3HP, infinitely variable speed lathe, and its a beauty!

This is a video of one of my Kerry Super 8 Drills. It has 4 speeds, plus back gearing giving eight speeds. My grandfather gave me one of these a few years back and i ended up giving it to a friend, but i had another 3! Very well made and very heavy.

A quick tour of my workshop. My messy tiny workshop. Sorry about the cracking sounds, it's my tripod hitting stuff as I move it.

This video shows how I rebuilt a vintage Parkinsons vice. Its around 100 years old, these were produced between 1880 and 1930. Its in pretty good shape to start with which helps, just lots of surface rust.

This video shows my axle as it gets an upgrade in the form of a Quaife ATB LSD. I have other mods on the axle for my 4 link coilover conversion and rear disc brakes. I had an issue with the diff, in that there was a manufacturing defect, but Quaife sorted it out for me under warranty. An LSD takes a lot of time and effort to set up (one reason for why its a long video), so if you don't feel com...

This is a power hacksaw my grandfather gave to me. It was seized up and needed a full restoration.

MG B GT Duratec R500 Engine

mgb duratec

mgb duratec

1968 MGB at brands hatch

MGB GT at brands

Spinning in the snow in my 1968 mgb gt

MGB Ready for Nurburgring

mgb gt v2 1

MGB GT BCV8 PETER BEST BRANDS HATCH 2008 CRASH