วีดีโอ

That’s hilarious. You say removing the spark arrestor makes it off-road only that’s exactly the opposite. The baffle is for forestry to keep you from starting fires while riding around in a forest.

Can these handle salt water ?

Modern small adventure bikes like the CRF300 and KLX are SOOO disappointing- strangled in power and nanny state ECUs. I agree with other offroad upgrades, but they should ALL have 30hp and over 20Nm stock without paying £100s in extras. No- I will get an old XR or TTR and tinker away!

I just can't get behind this particular mower because they don't cut very good unless you cut your lawn 1 inch high anything higher than that it totally is worthless it's a brush hog it's not a mower.😊

I may source better O-rings to replace the ones from Acerbis. The question is, neoprene, nitrile, viton, etc??

Thanks for the video KC. I just ordered my 14 front JT sprocket and 110 chain also JT, but I need your help in finding a rear 40 tooth sprocket to replace my oem. Could you please help out, I'd appreciate it so much. I see many in Amazon but don't know which to choose, Thanks. 😁

Time to trade that bad boy in on a new DR-Z4S!

👍

Where did you get the Kawasaki rap for the rear swing arm ?

The 4 washers they provided me are smaller than the inside diameter of the factory tube so I’m not sure how this will work. Very frustrating and disappointing. Will not recommend this manufacturer.

I actually had to install this leaving the fork leg on the bike, as I didn't have the proper tool to remove the axle and it was tight as ****. So, that can be done as well. I just had to ratchet strap the suspension down on the right leg to get at the damping rod and cap, then let it go to reinstall the cap. The bike is a whole lot less pitchy now on road and we'll see how it work off road when nice weather returns. K Tech rear shock already in.

Why do Americans insist on telling you a life story about everything or your buddy or had a buddy or what ever. I spend 10 minutes listing to someone else’s mind numbing life story by accident then realise I know nothing about the thing I was initially interested in and i have invested too much time giving a shit by now and move onto something else I’ll end up knowing nothing about

So you attach it direct to battery without the fuse wire attached? I tried it with the fuse wire attached and it shorted my entire bike. Now bike won't start.

Awesome terrain, what part of the states are you in?

Good review, thanks.

Just found your channel, great content, btw I have a 2021 CRF300L that I’m just getting around to suspension mods and will absorb your mods in every regard, thanks

I’m in the fence what to get for my 2006 crf 250x I want to race cross country events like the San Felipe 250 and the Baja 500 and don’t want to get pricked by bushes or shrubbery which is better

I cant wait to put a set of studded knobby's on for the winter. I'm in northern Alberta Canada.

what are the results?

I’ve been seeing reviews of the MSR boot for the price looks like a good pair to get unfortunately they’re unavailable in anything bigger than a 9 🤷🏻‍♂️

“Seat thong”😂😂

Mine is coming loose .you got any tips

This is really helpful! Thank you! Quick question, how did you wire the license plate light into the existing wire? The existing license plate has three wires and the tusk light only has positive and negative. Thank you!

O rings aren't really meant to "squish" that's when they fail.

would u recommend a ktm exc f 350 for a daily ride? (with a supermoto set up)

Very nice! Do you notice any excessive chain wear on the front slider on top of the swingarm, near the front sprocket, top of swingarm? KTM changed the swingarm design in 2025 due to chain tension and abnormal wear on the chain slider near the pivot point.

So you mean to tell me those trails are right off your driveway?

What good information, I have the same problem with my cable, I put the handlebars tusk big bar 1 1/8 my KLX is year 2025 do you think I can use the cable what you suggest in the video?

Looking at one on offer up now 😎

Great job. I like this idea vs $240++ for a prepackaged kit. They dont tell you that you can changeup the back with no special harness, as long as you keep the front directionals non-led. I'll keep my fronts stock till they break, they dont look too bad. Thanks for the vids!

Bought my klx from Stiller in Kitanning 6 months ago and I’m loving it. First bike in about 15 years. Took it to mountain ridge, going to check out rock run also. Any other good spots you recommend?

Do you know the injector flow rate? in liters per secund?

Hello, greetings from Argentina, I saw that you installed an enduro gear lever, could you tell me what the model is? thank you so much

Nice Video @STickerbao

Lol wish they made a klx 400 😢

Ia this with the stock exhaust modification? Or did you put the end piece with the screen back in the pipe aka spark arrestor?

Half the video was putting thay darn plastic heat shield 😂

Where did you get the aftermarket lever boots? The ones that came with the bike and screwed into the oem flag hand guards are in the way….

Just in case anyone in the future finds this video looking to do the same, a 106 chain did not fit in my case ('23 KLX300 DS). Had the wheel all the way forward and still a blonde one from sliding the master link in. Gonna try a 108 because it was at least do-able in KC's experience. Hope this helps! Thanks for the video!

Is the weight and suspension difference significant on that loop, at that speed?

do you make a vidéo soon?

No way for so little gains 😂🤣😂🤡🌎you could carry 2 gallons extra for the price of a gas can at $20

Sounds GREAT!

Where is this? Looks fun!

Sell em’ both and grab a 13-23 Ktm exc 500. 265 lbs wet,more nimble than the Klx,more power than the drz. One bike,does it all better than both of those.

Try a fatty tire in the front. I use goldentyre it mobs over everything.

Thank you for the vice grips trick!

Like the vid, but its the pic on the wall in the vintage frame…I have two myself. One of my great grandfather, and the other of his son. Just struck me, that’s all. 👍🤪🏳️‍🌈

What about the insulation between the slip on and the new header. I clamped it down and it leaks,

I thought that was a no brainer first step on every new dirtbike 🤣