วีดีโอ

Hey Benjamin, Danke für dein Kommentar. Wow, das ist recht heftig mit den Verschmelzungen. Aber da merkt man wieviel Power so ein "Spielzeug" hat.

Perfekt, dann ist alles noch stabiler. Das macht das Hobby ja umso interessanter. Da wird geschraubt, bis eine Lösung da ist. Super! Viel Spaß mit deinem Kraton!

Hello, in my case the main issue was the spring. So maybe you do not need to buy anything. Definately not the slipper plate & hub set. I cannot image what needs to happen to damage those. Try to make sure that the "spring" does not jam inside of the front slipper plate. You see it at 12:45 in my video: I could not get this spring out and it needs to move freely. Try to reduce the outer diameter of the spring (by squeezing or grinding material off). You can check if the sping is right by mounting the slipper clutch together and open it again: If the spring falls out then it is correct. Then also get sure that you use some blue loctite and put some on from the other side (that part with the thread - I hold it at 15:35). Than let it rest for at least 24 hours and only after that put it all back together in your truck. If your spring is already moving freely than you have some other issue, so I would recommend to go with the maintenance set. Hope you will find a solution. Good luck!!!

@@w.k.6010 Hi. Thank you for the reply. Yup I noticed when I opened the slipper clutch, the spring was stuck inside it. I will give it a try following your method. Thanks again.

@@w.k.6010 Hi there. I did the repair but I'm not sure whether I did it right. After I tighten the slipper screw & applied the loctite, the spur gear/clutch pad still rotate or moving. Is it suppose to be like this? Or it should not be moving at all? Appreciate if you could give an advice. Thks

@tara mizzi. Hi again. This is strange. Normally if you tight the scrwew all the way and open it just a bid (rotate back the screw 360°) you should not ne able to rotated it with your hands. Al least I couldn't do it. It sounds that something else is going on with your slipper clutch. And be careful with the loctite. Don't put it all back in the rc car directly. Wait for 2 days otherwise you will be not able to dismount it again. Any chance you could share some vids or Fotos from your slipper clutch? Sorry that I could not help you.

Hey, Danke. Werde ich machen. Aber ein "Gegen- Abo" ist dir sicher !

TH-cam need some mode time to change into better quality. I do not know how long it will take. But the video was filmed in 4k.

Thank you Ronan, I wish you the same. I will check out your channel.

Hey "by gun". Danke für dein Kommentar. Ich freue mich sehr, dass mein Gequatsche zumindest einem eine Lösung geboten hat. Aber bitte sei nicht so voreilig mit dem Wiedereinbauen, nachdem du mit Loctite gearbeitet hast. Sonst wirst du mich noch lange verfluchen! Es muss wirklich austrocknen. Lass da ruhig lieber 2 Tage vergehen. Wenn du Zeit findest, lass mich wissen, wie dein Ergebnis war. Viel Spaß mit dem Kraton, das ist auch ein Super RC- Car!